User manual FREECOM SUPERLOADER3 LTO2-HH

[. . . ] 2 Quantum SuperLoader 3 User's Guide, 81-81317-02 A01, September 2005. Quantum Corporation provides this publication "as is" without warranty of any kind, either express or implied, including but not limited to the implied warranties of merchantability or fitness for a particular purpose. Quantum Corporation may revise this publication from time to time without notice. Making copies or adaptations without prior written authorization of Quantum Corporation is prohibited by law and constitutes a punishable violation of the law. [. . . ] Press Enter to advance the cursor to the next digit. SuperLoader 3 Autoloader User's Guide 67 Chapter 5 Administration Setting the Change Mode 7 The next two digits represent the current hour. At each position of the hour, use the up and down arrows to change the value of each digit. At each position of the minute, use the up and down arrows to change the value of each digit. 10 Press Escape as necessary to return to the main menu. Setting the Change Mode You can set the autoloader to either Random or Sequential. The default change mode is Random. 5 In Random mode, you, or the backup software, can specify which cartridge you want to use and where you want it to go. The Sequential mode supports certain backup applications that do not manage media. During backup, when one cartridge is read or written to the end of the tape, the autoloader automatically returns that cartridge to its slot and loads the cartridge from the next higher numbered slot to the tape drive to be read or written to. The autoloader does not move the media until the host requests the tape drive to unload the tape via a SCSI unload command. Note: In Sequential mode, the medium changer does not appear in the Device Manager. The medium changer will reappear in Device Manager if you return the system to Random mode. This is to allow for operating systems that do not support multiple LUNS. In Seq Cycle mode, which is an option of the Sequential mode, the autoloader automatically starts over with magazine slot 1 when the last cartridge is used (slot 16 or highest filled slot). If this change mode is not set, the autoloader stops when the last cartridge available has been used. In Seq Cycle mode the autoloader continues to cycle until a user stops it. 68 SuperLoader 3 Autoloader User's Guide Chapter 5 Administration Setting the Change Mode To set the Change Mode: 1 From the main menu, scroll to Configuration, and then press Enter. 2 From the Configuration menu, scroll to Change Mode, and then press Enter. 3 Do one of the following: · · To leave the mode the same, press Escape. To modify the change mode, scroll to the mode to which you want to set the autoloader and press Enter. Reboot to enable new mode appears on the LCD. 4 Press and hold the power button on the front panel until System Shutdown wait 60 sec appears on the LCD. The new change mode is now in effect. Sequential Mode Operations 5 If you enable Sequential mode, you must use the Sequential Ops submenu under the Commands menu to operate the autoloader after you reboot. · · · The Start command allows you to load the first cartridge. The Resume command allows you to continue from the next unused slot, if a user stopped the cycle. The Stop command allows you to stop the cycle. To start Sequential mode operation: 1 From the main menu, scroll to Commands, and then press Enter. 2 From the Commands menu, scroll to Sequential Ops, and then press Enter. 3 From the Sequential Ops menu, scroll to Start, and then press Enter. [. . . ] An e-mail protocol on the Internet that defines the message format and the message transfer agent. A protocol that monitors and controls a network. SNTP Simple Network Time Protocol. SNTP is based on NTP, the Network Time Protocol, an industry standard way for computers to synchronize their time to an external reference standard. Each consists of a client, for example the SuperLoader, which obtains the current time (in UTC) from either an SNTP server or an NTP one. [. . . ]