User manual FORD CROWN-VICTORIA-2006

[. . . ] Table of Contents Introduction Instrument Cluster Warning and control lights Gauges 4 10 10 14 Entertainment Systems AM/FM AM/FM AM/FM AM/FM AM/FM stereo stereo stereo stereo stereo cassette with CD cassette with CD with cassette and in-dash six CD 17 17 19 21 25 30 Climate Controls Manual heating and air conditioning Automatic temperature control Rear window defroster 36 36 37 39 Lights Headlamps Turn signal control Bulb replacement 40 40 42 44 Driver Controls Windshield wiper/washer control Steering wheel adjustment Power windows Mirrors Speed control Message center 51 51 51 62 64 65 73 Locks and Security Keys Locks Anti-theft system 82 82 82 90 1 Table of Contents Seating and Safety Restraints Seating Safety restraints Airbags Child restraints 98 98 103 118 130 Tires, Wheels and Loading Tire Information Vehicle loading Trailer towing Recreational towing 142 142 156 162 165 Driving Starting Brakes Traction control Air suspension Transmission operation 167 167 171 174 176 177 Roadside Emergencies Getting roadside assistance Hazard flasher switch Fuel pump shut-off switch Fuses and relays Changing tires Lug Nut Torque Jump starting Wrecker towing 183 183 184 185 186 195 200 201 206 Customer Assistance Reporting safety defects (U. S. only) 207 213 Cleaning 214 2 Table of Contents Maintenance and Specifications Engine compartment Engine oil Battery Engine Coolant Fuel information Air filter(s) Part numbers Refill capacities Lubricant specifications 221 223 225 228 230 236 251 252 253 255 Accessories Index 260 262 All rights reserved. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company. Ford may change the contents without notice and without incurring obligation. [. . . ] Before placing the child in the seat, forcibly move the seat forward and back to make sure the seat is securely held in place. To check this, grab the seat at the belt path and attempt to move it side to side and forward. There should be no more than one inch of movement for proper installation. Try to pull the belt out of the retractor to make sure the retractor is in the automatic locking mode (you should not be able to pull more belt out). If the retractor is not locked, unbuckle the belt and repeat Steps 2 through 9. Check to make sure the child seat is properly secured before each use. 137 Seating and Safety Restraints Attaching child safety seats with tether straps Most new forward-facing child safety seats include a tether strap which goes over the back of the seat and hooks to an anchoring point. Tether straps are available as an accessory for many older safety seats. Contact the manufacturer of your child seat for information about ordering a tether strap. The rear seats of your vehicle are equipped with built-in tether strap anchors located behind the seats as described below. The tether anchors in your vehicle are located under a cover marked with the tether anchor symbol (shown with title). The tether strap anchors in your vehicle are in the following positions (shown from top view): Attach the tether strap only to the appropriate tether anchor as shown. The tether strap may not work properly if attached somewhere other than the correct tether anchor. For vehicles with adjustable head restraints, route the tether strap under the head restraint and between the head restraint posts, otherwise route the tether strap over the top of the seatback. Locate the correct anchor for the selected seating position. 138 Seating and Safety Restraints 4. If the tether strap is clipped incorrectly, the child safety seat may not be retained properly in the event of a collision. 6. Install the child safety seat tightly using the LATCH anchors or safety belts. Tighten the child safety seat tether strap according to the manufacturer's instructions. If the safety seat is not anchored properly, the risk of a child being injured in a collision greatly increases. 139 Seating and Safety Restraints Attaching safety seats with LATCH (Lower Anchors and Tethers for Children) attachments Some child safety seats have two rigid or webbing mounted attachments that connect to two anchors at certain seating positions in your vehicle. This type of child seat eliminates the need to use safety belts to attach the child seat. For forward-facing child seats, the tether strap must also be attached to the proper tether anchor. Your vehicle has LATCH anchors for child seat installation at the seating positions marked with the child seat symbol. [. . . ] Service refill capacities are determined by filling the rear axle 1/4 inch to 9/16 inch (6 mm to 14 mm) below the bottom of the filler hole. 7 6 254 Maintenance and Specifications LUBRICANT SPECIFICATIONS Item Brake fluid Ford part name Motorcraft High Performance DOT 3 Motor Vehicle Brake Fluid1 Silicone Spray Lubricant Motorcraft Premium Gold Engine Coolant (yellow-colored) Ford part Ford number specification PM-1 or PM-1-C ESA-M6C25-A or WSS-M6C62-A Door weatherstrips Engine coolant XL-6 ESR-M13P4-A WSSM97B51­A1 Engine oil Hinges, latches, striker plates, fuel filler door hinge and seat tracks Lock cylinders VC-7­A (except CA, OR and NM), VC-7-B (CA, OR and NM) Motorcraft SAE XO-5W20-QSP 5W-20 Premium (US) Synthetic Blend CXO-5W20­ Motor Oil (US) LSP12 (Canada) Motorcraft SAE 5W-20 Super Premium Motor Oil (Canada) Multi-Purpose XG-4 or XL-5 Grease WSS-M2C930-A with API Certification Mark ESB-M1C93-B Power steering fluid Motorcraft XL-1 Penetrating and Lock Lubricant Motorcraft XT-2-QDX MERCON Multi-Purpose ATF none MERCON 255 Maintenance and Specifications Item Automatic transmission (4R75E) Rear Axle Lubricant Ford part name Motorcraft MERCON V ATF3 Motorcraft SAE 80W-90 Premium Rear Axle Lubricant2 Motorcraft Premuim Windshield Washer Concentrate Ford part number XT-5-QM Ford specification MERCON V XY-80W90-QL WSP-M2C197-A Windshield washer fluid ZC-32-A WSB-M8B16­A2 1 Use only brake fluids certified to meet Ford specifications. However, if DOT 3 is not available, DOT 4 fluid can be used. Add 4 oz. (118 ml) of Additive Friction Modifier XL­3 or equivalent meeting Ford specification EST-M2C118-A for complete refill of Traction-Lok rear axles. Transmission fluid requirements are indicated on the dipstick or on the dipstick handle. [. . . ]