User manual FIELD CONTROLS 46520200

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual FIELD CONTROLS 46520200. We hope that this FIELD CONTROLS 46520200 user guide will be useful to you.


FIELD CONTROLS 46520200 : Download the complete user guide (503 Ko)

Manual abstract: user guide FIELD CONTROLS 46520200

Detailed instructions for use are in the User's Guide.

[. . . ] · After opening the carton, unpack and inspect the unit and lamp for damage. If lamp is damaged, cracked or broken, do not touch lamp or other contents in carton. · In case of accidental exposure to internal contents of lamp, wash hands and any other affected skin area with mild detergent. [. . . ] However, when deciding on a suitable location, the mounting screw head can not be in the shaded area of template. (See Figure 5) Figure 1 Figure 2 Figure 3 Figure 4 Head of mounting screw CAN NOT be located in shaded area Figure 5 WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Attach the UV-Aire mounting base onto the plenum with the supplied sheet metal screws. (Refer to template as shown in Figure 3) This must be tight in order to activate the built in safety switch. (See Figure 7) The power cord must be 90° to the viewport hole on the mounting base. With the ballast pressed against the mounting base, rotate the ballast clockwise 90°. Do not wire the unit into the appliances 24 volt fan or thermostat circuit. NOTE: The viewport hole is made of glass and will not allow any UVC rays to pass through. If blue glow is not seen, make sure the base is properly installed onto duct. There is a proving switch located on the base that needs to be seated properly onto the duct. Make sure when installing the base the plated washer on the switch is raised approximately 3/16". With aluminum or foil tape, seal all joints and seams of the plenum near the mounting location to reduce any direct viewing of light. Figure 6 Figure 7 Figure 8 WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. [. . . ] UV lamps contain a small amount of mercury, like a typical fluorescent lamp. Check with your local waste management authority for local disposal or recycling requirements. According to the EPA's Universal Waste Rule, these types of lamps may be disposed of into household waste. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE FIELD CONTROLS 46520200




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual FIELD CONTROLS 46520200 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.