User manual FIELD CONTROLS 46334900

[. . . ] P/N 46334900 INSTALLATION INSTRUCTIONS Designed for use with the SWG Series Power Venter for controlling Natural Gas or L. P. Items included in Kit: 1) Junction box with mounted pressure switch and post purge timer 1) Fan control gas pressure switch 1) 2 ft. length of 1/4 inch aluminum tubing 2) Flexible conduit connector 1) 1/4 inch tubing connector MOUNTING JUNCTION BOX: The junction box can be mounted at the venter or remotely mounted away from the venter. [. . . ] Remove one of the knockouts from the side of the junction box where the pressure switch is mounted. Install the flexible conduit connector onto the CK40F junction box and secure with fastening nut. If remote mounting the CK-40F junction box, mount the flexible conduit connector onto a 2" x 4" installer supplied junction box. Fasten the flexible conduit from the SWG Venter into the conduit connector. Mount the CK-40F junction box or installer supplied junction box onto the wall or floor joist without straining the flexible conduit. Fasten the CK-40F junction box through the four dimpled locations on the base of the box. 3) After venting kit installation and checkout, check the amperage current draw through the thermostat circuit and adjust the thermostat anticipator accordingly. Figure 3 Page 2 Page 3 WIRING INSTRUCTIONS CAUTION: DISCONNECT ELECTRICAL POWER WHEN WIRING POWER VENTER Wire the venter motor and controls in accordance with the National Electrical Code, manufacturer's recommendations and/or applicable local codes. Check ground circuit to make certain that the unit has been properly grounded. The wiring should be protected by an overcurrent circuit device rated at 15 amperes. CAUTION must be taken to ensure that the wiring does not come into contact with any heat source. All line voltage and safety control circuits, between the venter and the appliance, MUST be wired in accordance with the National Electrical Code for class one wiring or equivalent methods. Route the venter motor and control wiring with an appropriate wiring method. With boilers, locate terminal on spark ignition module or gas valve (if standing pilot) which would normally be 24 volts hot on a call for heat. With spark ignition systems, this terminal could be THW, 24 V, THS or T1 depending on the spark ignition control. [. . . ] This should open the pressure switch contacts and stop burner operation. TROUBLE SHOOTING HINTS 1. Check gas pressure switch for continuity across terminals when gas valve is pressurized. Diagram A Page 4 Page 5 INTERNAL WIRING FOR CK-CONTROL KIT: DIAGRAM A & B L1 TO 1 ON POST PURGE TIMER M TO 3 ON POST PURGE TIMER T1 TO COMMON ON PRESSURE SWITCH T2 TO TIMER RELAY BASE T3 TO N/O ON PRESSURE SWITCH TIMER BASE TO COMMON ON PRESSURE SWITCH Diagram B DO NOT DESTROY THESE INSTRUCTIONS MUST REMAIN WITH EQUIPMENT Installation Information Model No. : _______________________________________ Installer's Name: __________________________________ Installer's Company:________________________________ Phone No. : _______________________________________ Date of Installation: ________________________________ REPAIR AND REPLACEMENT PARTS LIST FOR CK-CONTROL KIT Pressure Switch Post Purge Timer P/N 46273100 P/N 46282800 Page 6 Page 7 [. . . ]