User manual FIELD CONTROLS 46150400

[. . . ] REPAIR MOTOR KIT Model: SWG CAUTION: Before working on power venter, shut off electrical power to control box ITEMS INCLUDED IN KIT: For kit with conduit clamp on motor 1) Replacement motor assembly with blower wheel 6) #8-18 x 1/4" screws For kit with an electrical box on motor 1) Replacement motor assembly with blower wheel 6) #8-18 x 1/4" screws 1) 3/8" conduit connector 3) Wire nuts 3) 18GA motor lead wires REMOVAL FOR KIT WITH CONDUIT CLAMP ON MOTOR 1. [. . . ] Using two nails or awls, align the two center holes of the motor mount bracket and cover plate. Locate the motor assembly into position by sliding the assembly over the mounting holes in the front plate. (See Figure 6) Secure motor assembly into position at the four corners, then secure center two holes. Route the wires from the new motor repair kit through the conduit and attach to the control kit in the appropriate location. Seal the top edge of the motor assembly with a high temperature silicone sealant. Insert the blower wheel into the hole in the front plate of the venter housing. [. . . ] Install the motor cover with the side louvers pointing downward. Figure 1 Figure 2 Figure 3 Figure 4 Figure 5 Figure 6 Page 2 P/N 46150400 Rev B 01/01 [. . . ]