User manual FIELD CONTROLS 46096300

[. . . ] SIDE WALL VENT HOOD Model: SWH-1-Four through Eight CAUTION: Read instructions prior to installation. This device should be installed in accordance with the National Fuel Gas Code; A. N. S. I. , Z223. 1 (See Requirements Below) and any local codes which are applicable. [. . . ] DO NOT DESTROY THESE INSTRUCTIONS MUST REMAIN WITH EQUIPMENT INSTALLATION SAFETY INSTRUCTIONS CAUTION: This device must be installed by a qualified installer in accordance with the manufacturer's installation instructions and applicable codes. Plan the vent system layout to avoid the possibility of accidental contact with concealed wiring or plumbing inside of wall. Single wall vent pipe may be used to join an appliance to the power venter; but, if proper clearance cannot be maintained from combustible material or when passing through a side wall, Class "B" type vent pipe should be used for gas appliances and Class "L" type vent pipe for oil appliances. The power venter should be installed as close to the termination of the vent system as possible to reduce effects of wind, outlet blockage and to guard against flue gas leakage. Pipe joints and seams should be sealed with a high temperature silicone adhesive sealant or equivalent. Test vent connections for leaks by using a soap solution as recommended by the National Fuel Gas Code: A. N. S. I. Vent hood inlet diameter should never be smaller than the installed vent pipe. Cut hole 1/2 inch larger than marked hole to facilitate easy installation. [. . . ] Please refer to the owners manual for complete system installation and safety instructions, multiple venting systems, trouble shooting hints and maintenance instructions. P/N 46096300 Rev A 02/01 [. . . ]