User manual FIELD CONTROLS 46094300

[. . . ] It is designed to regulate chimney draft with a high degree of accuracy and fuel efficiency. DO NOT DESTROY THESE INSTRUCTIONS MUST REMAIN WITH EQUIPMENT WEIGHT ASSEMBLY Attach weight assembly to damper prior to its installation in flue pipe. LOCATION OF DRAFT CONTROL BEST LOCATIONS FOR SOLID FUELS Determine the best locations to mount the draft regulator using Figures 2-7. [. . . ] LOCATION OF DRAFT CONTROL BEST LOCATIONS FOR SOLID FUELS Determine the best locations to mount the draft regulator using Figures 2-7. MOUNTING CONSIDERATIONS Damper must be mounted with the hinge pins horizontal and the face of the damper plumb for correct operation. This is done by rotating the damper section within the collar for any pipe position. (See Figure 8) BALANCING WEIGHT ASSEMBLY AND DRAFT ADJUSTMENT FOR WOOD AND COAL FIRED APPLICATIONS 1. Assemble the "counter balance weight assembly" to the draft control as shown in Figure 1. Thread "counter balance weight" through "threaded nut" attached to the gate. Assemble the "counter balance weight assembly" to the draft control as shown in Figure 1. Thread "counter balance weight" through "threaded nut" attached to the gate. Assemble "hex nut"" and "knurled nut" on front of gate as shown in Figure 1. Proper operation of the regulator depends upon proper installation and adjustment. Use a CO2 indicator, stack thermometer and draft gauge to adjust draft for oil fired burners. Domestic oil burners work best with the draft over fire of . 01 to . 02-inches W. C. [. . . ] Use a CO2 indicator, stack thermometer and draft gauge to adjust draft for oil fired burners. Domestic oil burners work best with the draft over fire of . 01 to . 02-inches W. C. [. . . ]