User manual FIELD CONTROLS 00575300

[. . . ] Phone: E-mail: (252)522-3031 fieldtec@fieldcontrols. com PRODUCT QUESTIONS. . . CALL FIELD FIRST English . . . . . . . Page 1 Français . . . . . Page 5 Espanõl . . . . . . Page 8 Shaded portions indicate dead or turbulent air. CAUTION: Do not use the TurboMistTM in a down-flow furnace. [. . . ] (The type where the heated air output is from the bottom of the furnace. ) INSTALLATION Refer to Figure 1 and Figure 2 for suggested humidifier locations. In installations where more than one humidifier is used do not place them in a position so that one obstructs the air flow of the other. WARNING: Locate the A-COIL before cutting into plenum chamber. Figure 1 1. (DO NOT INSTALL SADDLE VALVE on any water pipe which is downstream from a water softener. ) Insert baffle if air flow is not directed properly to make turbine and evaporator revolve. Place level in humidifier body to make sure humidifier is level front to back. NOTE: See saddle valve assembly package for additional instructions. Figure 6 Figure 7 Figure 8 6. Be sure float does not touch any part of the pan and is free to move up and down. The rising and lowering of the float will automatically shut off or replenish the water supply. A 1/4" diameter tube should be inserted into the water overflow hole in the pan (See Figure 4) for any excess water drainage. Page 3 MAINTENANCE Your Field TurboMistTM Humidifier puts pure water in the air and traps impurities on the evaporator discs and in the water pan. At the end of each heating season the water pan and float should be cleaned and the saddle valve turned off. [. . . ] At the end of each heating season the water pan and float should be cleaned and the saddle valve turned off. REPLACEMENT PARTS The float valve assembly, evaporator assembly and saddle valve assembly can be obtained as replacement parts as necessary. [. . . ]