User manual FESTOOL T 15PLUS3

[. . . ] The tool blocks if: - the power tool is overloaded or - it becomes jammed in the workpiece being processed. ­ Wait until the power tool stops completely until placing it down. The tool can become entangled and lead to a loss of control of the power tool. Carrying the power tool with your finger at the on/off switch, or inserting the battery when the power tool is switched on, can result in accidents. [. . . ] 3 Charger wall mount The charger TRC 3 has two elongated holes on its back. 3 Fastening Adjust the switch so that [1-8] its marking faces the screw [1-7] symbol. l The switch-over function only works if the machine is switched off. X Adjust the torque accordingly at the torque [1-10] wheel: Position 1 = low torque Position 25 = high torque The machine switches off when the preset torque is reached and an acoustic signal sounds. The machine only continues running when the on/off switch is [1-3] released and then pressed again. 4 Drilling Adjust the switch [1-8] so that its marking faces the drilling symbol [1-6]. Risk of injury, electric shock X Always disconnect the battery pack before any type of work on the machine!1 Tool chuck CENTROTEC WH-CE [4] The tool chuck CENTROTEC WH-CE allows you to change tools with a CENTROTEC shank in a matter of seconds. Tool has sharp edges and can cause cutting injuries during a tool change. 4 Eccentric attachment DD-ES [7] The eccentric attachment (in part, additional equipment) permits screwdriving near edges with bits according to DIN 3126. 5 Tool holder in the drill spindle [8] Bits can be inserted directly in the hexagon socket holder on the drill spindle to shorten and reduce the weight of the machine. Observe the following instructions: ­ Keep the air slits on the machine and the charger free and clean to ensure adequate cooling. ⭠Keep the contacts on the machine , charger and battery pack clean. Information on battery packs ­ Where possible, store the battery pack in a cool, dry place at a temperature between 5 °C and 25 °C. ­ Battery packs are most efficient at temperatures between 20 °C and 30 °C. ⭠Protect the battery pack from moisture , water and heat. ­ Significantly shorter operating times after each charge indicate that the battery pack is worn and should be replaced with a new one. ­ The LiIon battery pack is fully compatible with the charger! integrated electronics prevent overloading and overheating during the charging process. ­ Do not leave flat battery packs in a charger disconnected from the mains power supply for longer than one month. There is a risk of total discharge and the maximum power of the battery pack may decrease. ­ Store the battery pack in its packaging to reduce the risk of short circuits. [. . . ] Note Due to continuous research and development work, we reserve the right to make changes to the technical content of this documentation. The equivalent amount of lithium in the LiIon battery pack is less than the applicable limit value and certified as per UN manual ST/SG/ AC. The LiIon battery pack is therefore not subject to national and international dangerous goods regulations, neither as an individual component nor as a fitted machine component. However, dangerous goods regulations may apply when several battery packs are transported, in which case you may have to fulfil special conditions. [. . . ]