User manual FESTOOL SE-HL

[. . . ] 1 Correct usage The SE-HL device for bench mounting has been designed to hold the Festool HL 850 EB planes so that it can be operated upside down as stationary tool. 2 Preparatory work on the plane Set the plane to a cutting depth of 0 mm and lock with the locking lever. [. . . ] 6) and bore hole in the housing before fastening with the rotary knob (1. 2) fit in the guide groove of the rebate depth stop on the plane housing. Lock the plane by turning the rotary knob screw with a short thread (1. Turn the scale ring until the zero position is exactly in line with the marking on the plane housing (2. If you release the plane's cutting depth lock you can now set the desired cutting depth on the scale by turning the additional hand grip. 2 Using a stop The stop must always be used so that that part of the planer head which is not in use is covered at every planing width. 3 Using a feed device A feed device should be used when planing small workpieces. 4 Fastening the device for bench mounting Before starting work make sure that the device for bench mounting is fixed securely to the base (table), for example with clamps. 5) of the rear mounting and onto the plane's pistol switch until you feel a slight resistance. To switch the plane on, press the plane's switch lock and push the switch clip fully onto the handle. 6 Working with a stop The plane can be used with the parallel stop PAHL, included with the plane, or the angle stop WA-HL, available as an accessory. 485018) The angle stop has two decisive advantages over the normal parallel stop: - the stop area is much larger and can also be infinitely adjusted between 0 and 45°. [. . . ] As "downstream users" and product manufacturers, we are aware of our duty to provide our customers with information. We have set up the following website to keep you updated with all the latest news and provide you with information on all the materials used in our existing products: www. [. . . ]