User manual FESTOOL RS 100 Q-PLUS

[. . . ] The specified illustrations can be found at the beginning of the operating instructions. - The manufacturer’s handling and processing instructions must be observed without fail if explosive or self-igniting dusts are likely to occur during sanding. Contact with these dusts, especially inhaling them, can represent a hazard for operating personnel or persons in the vicinity. 3 Noise and vibration information The typical values determined in accordance with EN 60745 are: Sound-pressure level 80 dB(A) Sound-power level 91 dB(A) Measuring uncertainty allowance K = 3 dB Wear ear protection! [. . . ] Unperforated abrasives can be perforated with the „Lochfix“ (accessory). - Before affixing any abrasives, attach a Stickfix abrasive sheet to the sanding pad first so that the adhesive coating on the Stickfix sanding pad is not damaged. Once clamped in position, make sure the abrasive paper is taut and sits flat on the sanding pad. 5) can be attached for tasks where the front edge of the sanding pad sands up to edges. 4 Machine settings Always remove the power supply plug from the socket before carrying out any work on the machine. Dust extractors prevent large accumulations of dust in the air in the working environment and dirt collecting at the workplace. You can connect a Festool extractor with an extractor hose diameter of 27 mm to the extractor connector (1. Sanding dust is extracted through the extraction channels in the sanding pad directly to the material removal point. 2) to allow air to enter prevents the machine from sticking to flat surfaces when processing workpieces. 5 Instructions on application Never overload the tool by using too much pressure!The best sanding results are achieved when applying moderate pressure. The sanding performance and quality depend mainly on the choice of the right sanding material. Metalworking The following precautions are to be taken when processing metals for safety reasons: - Pre-connect a residual current circuit-breaker (FI, PRCD). Stickfix abrasives The appropriate Stickfix sanding paper and Stickfix sanding felt can be fastened quickly and easily onto the Stickfix sanding pad. The self-adhesive sanding material is simply pressed onto the sanding base and held safely in place by the Stickfix sanding base velcro surface. 6 Accessories Use only original Festool accessories and Festool consumable material designed for this machine because these system components are designed specifically for the machine. Using accessories and consumable material from other suppliers will most likely affect the quality of your working results and limit any warranty claims. Machine wear or your own personal workload may increase 10 depending on the application. Protect yourself and your machine, and preserve your warranty claims by always using original Festool accessories and Festool consumable material!The order numbers of the accessories and tools can be found in the Festool catalogue or on the Internet under “www. [. . . ] 9 Warranty For our tools, we give warranty for material and production defects in accordance with the locally applicable legal provisions, but in any case for at REACH for Festool products, their accessories and consumables REACh is a European Chemical Directive that came into effect in 2007. As “downstream users” and product manufacturers, we are aware of our duty to provide our customers with information. We have set up the following website to keep you updated with all the latest news and provide you with information on all the materials used in our existing products: www. Nedan använt begrepp ”Elverktyg” hänför sig till nätdrivna elverktyg (med nätsladd) och till batteridrivna elverktyg (sladdlösa). [. . . ]