User manual FESTOOL OF1010EQ

[. . . ] 3 Noise and vibration information The typical values determined in accordance with EN 60745 are: Sound-pressure level/sound-power level OF 1010 EBQ, OF 1010 EQ 79/90 dB(A) OF 1010 Q 87/98 dB(A) Measuring uncertainty allowance K = 3 dB Wear ear protection! Overall vibration levels (vector sum for three directions) measured in accordance with EN 60745: Vibration emission level (3-axis) ah = 5, 5 m/s2 Front handle ah = 8, 0 m/s2 Uncertainty K = 2, 0 m/s² The emission values specified (vibration, noise) were measured in accordance with the test conditions stipulated in EN 60745 and are intended for machine comparisons. They are also used for Making preliminary estimates regarding vibration and noise loads during operation. The emission values specified refer to the main applications for which the power tool is used. [. . . ] The individual height of each sensing stop can be adjusted with a screwdriver: Sensing stop min. B) Setting the milling depth The desired milling depth can be set either with the quick depth adjustment or with the fine depth adjustment. Turn the adjusting wheel to the next mark on the scale to adjust the milling depth by 0. With edge routing, the best extraction effect is obtained with the extractor hood AH-OF, available as an accessory. 1) (sometimes included in the scope of delivery), the efficiency of the extraction can be increased when routing edges. The chip catcher can then be used for interior radiuses up to a minimum radius of 40 mm. Working with the machine Always secure the workpiece in such a manner that it cannot move while being sawed. The machine must always be held with both hands by the designated handles (1. When routing (ensure feed direction of power tool is the same as cutting direction of tool, Fig. Aluminium processing When processing aluminium, the following measures must be taken for safety reasons: - Pre-connect a residual current circuit-breaker (FI, PRCD). 2 Freehand routing Freehand routing is the method normally used for lettering or shapes, and for routing edges using cutters with a guide pin or ring. 2) supplied can be used for routing parallel to the edge of the workpiece (not supplied with , , Module 5A): - Secure both guide rods (3. 10) on the router base to the required distance and secure them by turning the rotary knob (3. This distance can be adjusted faster and more precisely with the fine precision adjustment (3. 3) of the parallel guide, - set the desired distance with the adjusting screw and retighten the rotating knobs. 4 Routing with the TV-OF extension table The extension table TV-OF, available as an accessory, can be used to enlarge the support area of the router and thus improve guidance, e. 5 Routing with the FS guide system The guide system, available as an accessory, facilitates routing straight grooves. 4) of 5 mm between the front edge of the guide rail and cutter or groove is observed. To ensure a backlash-free guidance of the router stop you can adjust two guide cheeks with a screwdriver through the side openings (4. Routing with the SZ-OF 1000 beam compasses With the SZ-OF 1000 beam compasses, which are available as an accessory, you can make circular cuts or segments of circles with diameters from 153 to 760 mm. - The beam compasses are pushed into the front groove of the platen until the desired radius is set. Practical hint To prevent the tip of the compasses from making a hole in the workpiece, fix a thin board at the centre point by means of double-sided adhesive tape. [. . . ] Maintenance and care Always remove the power supply plug from the socket before carrying out any work on the machine. All maintenance and repair work which requires the motor casing to be opened may only be carried out by an authorised service centre. The tool is fitted with special motor brushes with an automatic cut-out. When the brushes become worn the power supply is shut off automatically and the tool comes to a standstill. [. . . ]