User manual FESTOOL MFK 700 EQ

[. . . ] 3 Emission levels Noise levels are measured in accordance with EN 60745: Sound pressure level LPA = 78 dB(A) Noise level LWA = 89 dB(A) Uncertainty K = 3 dB Risk of accident if the machine is operated using unauthorised voltages or frequencies. - The mains voltage and the frequency of the power source must correspond with the specifications on the machine's name plate. - In North America, only Festool machines with voltage specifications of 120 V may be used. Always pull the plug out of the socket before performing any type of work on the machine. [. . . ] 4 Changing the clamping collet Only compatible tools can be used in combination with the clamping collets supplied. Remove the locking nut from the spindle together with the clamping collet [7-3]. Do not separate the locking nut and clamping collet as these form a single component. Extraction hoods are supplied for both router tables; a Festool extractor (extractor hose with a diameter of 27 mm) can be connected to these extraction hoods. 27 mm) can also be attached to the large surface router table or the side stop depending on the application. Risk of accident - the routing tool may be hot after use and has sharp edges. Unscrew the locking nut [6-2] using the openend wrench (size 19) until you are able to remove The machine is then guided in such a way that the sensor rests against the workpiece. Always secure the workpiece in such a manner that it cannot move while being routed. The side stop can only be fitted to the large surface router table without a fitted extraction hood [4-2]. Secure both guide rods [9-5] with the two rotary knobs [9-2] on the side stop. Insert the side stop into the grooves on the router table to the required distance and secure the guide rods by turning the rotary knob [9-1]. Loosen the screws [9-2] and turn the green wheel on the fine adjuster [9-3]. 10] Use routing tools with a bearing guide in the machine when edge trimming with the large surface router table. The machine is then guided in such a way that the bearing guide rolls off the workpiece. When trimming edges, always use the extraction hood [10-1] for improved dust extraction. 11] When edge trimming with the router table for edge veneer (only in SET scope of delivery), fit the sensor [11-1] to the machine (see Chapter 7. Risk of accident - always perform the following safety measures when routing aluminium: · Always pull the plug out of the socket before performing any type of work on the machine. All maintenance and repair work which requires the motor housing to be opened must only be carried out by an authorised service workshop. Check the plug and the cable regularly and should either become damaged, have them replaced by an authorised after-sales service workshop. To ensure constant air circulation, always keep the air vent slits in the motor housing clean and free of blockages. [. . . ] Otherwise the respective, current warranty conditions of the manufacturer shall apply. Note Due to continuous research and development work, we reserve the right to make changes to the technical content of this documentation. We declare at our sole responsibility that this product is in conformity with the following standards or standardised documents: EN 60745-1, EN 60745-2-17, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3 in accordance with the regulations 2006/42/EC, 2004/108/EC. REACH for Festool products, their accessories and consumables REACh is a European Chemical Directive that came into effect in 2007. [. . . ]