User manual FESTOOL LRS 93 M

[. . . ] Operate and service the air tool as described in the recommendations included in these instructions and use accessories and attachments from Festool to minimise the release of dust and vapours into the atmosphere. In dusty environments, make sure that the dissipation of exhaust air does not disturb the dust. I) Do not use the compressed-air hose for purposes for which it was not intended. These clamp the workpiece more securely than with hands and also allow both hands to be free to operate the pneumatic tool. [. . . ] ­ The permissible rotational speed of the accessory must be at least as high as the maximum speed specified on the machine. Accessories that rotate faster than the permissible level can rupture. ­ Proceed with caution in unfamiliar surroundings that may contain electricity or other supply cables that harbour hidden dangers. Make sure that there are no electrical cables, gas pipelines or similar that, if damaged, could pose a hazard when the machine is used. 3 Residual risks In spite of compliance with all relevant design regulations, dangers may still present themselves when the machine is operated, e. : ­ Workpiece parts being thrown off, ­ Parts of damaged tools being thrown off, ­ Noise emission, ­ Wooddust emission. 4 Emission levels Levels determined in accordance with EN ISO 15744/EN ISO 8662 are typically: Sound pressure level Noise level Measuring uncertainty allowance Operating noise Damage to hearing X Wear ear protection!Levels determined in accordance with EN ISO 15744/EN ISO 8662 are typically: Measured acceleration < 2, 5 m/s2 Uncertainty K = 1, 5 m/s2 The emission values specified (vibration, noise) were measured in accordance with the test conditions stipulated in EN 60745 and are intended for machine comparisons. They are also used for making preliminary estimates regarding vibration and noise loads during operation. the emission values specified refer to the main applications for which the air tool is used. If the air tool is used for other applications, with other tools or is not maintained sufficiently prior to operation, however, the vibration and noise load may be higher when the tool is used. Take into account any machine idling times and downtimes to estimate these values more accurately for a specified time period. This may significantly reduce the load during the machine operating period. Risk of injury X Make sure that the pneumatic tool is switched off when you connect the compressed-air supply. 1 Compressed-air processing The Festool service unit should always be used to ensure that Festool pneumatic tools function correctly. Consisting of a filter, control unit, condensation drain and lubricator, the service unit Cleans and lubricates the compressed air and keeps it free of condensation. Here, the lubricator should be set so that a drop is applied to the compressed air approx. L We recommend a service unit with a 3/8" connector, when up to two Festool pneumatic tools are used. A compressor that supplies at 500 l/min and at an operating pressure of 6 bar should be used to supply compressed-air. The diameter of the piping system must be sufficiently large (at least 9 mm). This hose system combines three functions in one hose: · X Then apply abrasive onto sanding pad, pull tight and clamp with the front lever. Fasten abrasive with StickFix The suitable StickFix sandpaper and StickFix sanding cloth can be attached quickly and simply to the StickFix sanding pad. [. . . ] Using accessories and consumable material from other suppliers will most likely affect the quality of your working results and limit any warranty claims. Machine wear or your own personal workload may increase depending on the application. Protect yourself and your machine, and preserve your warranty claims by always using original Festool accessories and Festool consumable material! festool offers the appropriate sanding and polishing attachments for every application. [. . . ]