User manual FESTOOL HL 850 EB

[. . . ] 5 m/s² Uncertainty K = 1, 5 m/s² The emission values specified (vibration, noise) were measured in accordance with the test conditions stipulated in EN 60745 and are intended for machine comparisons. They are also used for making preliminary estimates regarding vibration and noise loads during operation. The emission values specified refer to the main applications for which the power tool is used. If the electric power tool is used for other applications, with other tools or is not maintained sufficiently prior to operation, however, the vibration and noise load may be higher when the tool is used. [. . . ] Machine settings Always remove the power supply plug from the socket before carrying out any work on the machine. By turning the handle beyond the 0 mm marking, you reach position P = Park position. In position P, the planer head cutter is pulled back completely behind the planer platen. 2 Planing head, planer blade Use only cutters which are sharp and undamaged. blunt cutters increase the danger of kick-back and reduce the planing quality obtained. The planer is equipped with planer head HK 82 SD 11 The machine must always be held with both hands by the designated handles (1. - Place The front platen onto The workpiece but do not allow The planer head to come into contact with The wood. Press on The front planer platen when starting to plane and on The rear planer platen (end of workpiece) when continuing or finishing planing. When work is completed, the protective cover moves back automatically to initial position through spring force. 2 Chamfering The front planer platen is equipped with a 90° V groove (2. This V groove is 2 mm deep, thus producing a 2 mm edge chamfer with the chip thickness setting 0. 3 Bench-mounted operation The planer can be operated bench-mounted in conjunction with the bench-mounting device SE-HL. 4 Rustic planer heads (accessories) The planer can also be used to create rustic surfaces. Three rustic planer heads are available for this purpose: - HK 82 RG: creates a surface with a coarse structure. When using rustic planing heads on the planer, set the cutting depth to 0 mm. 5) to the lower edge of the chip removal opening and screwed in by means of rotary button (5. 36 mm) can either be fitted directly in the chip removal opening, or in the adapter AD-HL for the chip collecting bag. 6 Putting the planer down When working with electric planers you must remember that the planer shaft continues to run for a few seconds after the tool is switched off. 8) at the end of the platen so that it can be placed safely on a work surface. If the electric tool is taken up, the support foot automatically protrudes beyond the planer platen to ensure that the planer shaft is always raised above flat work surfaces when the planer is put down. Pay attention to the following when putting the HL 850 EB down: - check that the support foot is present and fully operational, - wait until the planer shaft comes to a standstill before putting the tool down. If the support foot should be found obstructive during special planing work it can be swung back out of the way and locked in position (2. [. . . ] Complaints will only be acknowledged if the equipment has not been dismantled before being sent back to the suppliers or to an authorised Festool customer support workshop. Store the operating instructions, safety notes, spare parts list and proof of purchase in a safe place. Note We reserve the right to make changes to the technical data contained in this information as a result of ongoing research and development work. EU only: European Directive 2002/96/EC stipulate that used electric power tools must be collected separately and disposed of at an environmentally responsible recycling centre. [. . . ]