User manual FESTOOL CTL44E

[. . . ] - Check the plugs and cables regularly and have them replaced by an expert if damaged. - Do not lift or carry the devices by their handles using a crane hook or lifting gear. - The device may only be used by persons who have been trained in its use and who are authorised to do so. - If noxious dusts have been extracted, the vacuum cleaner and all accessories must be completely cleaned (inside and outside) by suction and wiping, before removal from the contaminated area. [. . . ] Make sure that the electric tool is switched off when plugging it in and unplugging it. Connecting pneumatic tools Make sure that the pneumatic tool is switched off when plugging it in and unplugging it. 8) (452829; supplied ready with CTL 44 LE) is fitted, the automatic cut-in of the appliance also operates in conjunction with compressed-air tools. The supply unit filters and oils the compressed air and allows the air pressure to be regulated. An IAS connecting piece (454757) is available for connecting Festool compressed-air tools with the IAS system. To ensure trouble-free functioning of the automatic cut-in, the operating pressure of the tool must be 6 bar. You must raise the upper part slightly before depressing or disengaging the support. Changing the filter During the following procedure, take care not to raise dust more than is unavoidable. : CTL 44 E/CTL 44 LE 452972 CTL 55 E 452973 - Open the vacuum cleaner, - Remove the used filter bag (see printed text on filter bag), - Dispose of the used filter bag in accordance with statutory requirements, - Thoroughly clean the dirt container (2. 1) for suction turbine (wipe down with a damp cloth), - Insert new filter bag (see printed text on filter bag). - Open the vacuum cleaner, - Remove the used filter element (see printed text on the filter element packaging), - Dispose of the used filter element in a sealed, dust-tight bag in accordance with statutory requirements, - Thoroughly clean dirt container (2. 1) for the suction turbine (wipe down with a damp cloth), - Fit a new filter element (see printed text on the filter element packaging), - Close vacuum cleaner. : You need to clean the filter element only if you use the vacuum cleaner without a filter bag. Warning: Make sure that both upper-part pins are fully inserted in the recesses (1. 8), thus preventing the vacuum cleaner from rolling away unexpectedly. When work is complete, you can guide the extractor hose through the opening (4. Tools or accessories can also be stowed on the storage area and in the storage compartments (1. The suction hose is connected to the tool from above with the hose coupling. Vacuuming dry materials A filter bag must be used without exception when evacuating noxious substances!Before using the vacuum cleaner to evacuate dry substances, a filter bag must always be inserted in the container. [. . . ] Complaints can only be recognised if the tool is returned while still assembled to the supplier or an authorised Festool Customer Service workshop. Keep the Operating Instructions, Safety Instructions, Spare Parts List and purchase receipt in a safe place. Otherwise the respective, current warranty conditions of the manufacturer shall apply. Note Due to continuous research and development work, we reserve the right to make changes to the technical content of this documentation. [. . . ]