User manual FESTOOL CTL 36 E LE

[. . . ] Always replace the mains power cable with the type specified in the spare parts list. ­ The machine should only be used by appointed persons instructed in correct machine handling. ­ Before use, operators shall be provided with information, instruction and training for the use of the machine and the substances for which it is to be used, including the safe method of removal and disposal of the material collected. ­ For reasons of safety, never operate the machine from an unearthed socket. [. . . ] L Make sure that the filter bag is not pinched between the top and bottom sections. X Dispose of the used disposal bag in accordance with statutory regulations. Inserting the disposal bag [7] X Insert a new disposal bag (ENS-CT26/36) on the inlet nozzle of the container and lock in position. Important: The lateral openings on the disposal bag must be positioned inside the container. 1 Handling Hose store: after finishing work, you can feed the suction hose through the recess [83] and place it in the hose store. You can do the same with the mains cable through the other recess [8-2]. SysDoc Systainer attachment system: a Systainer can be attached to the storage area via the two slides [8-1]. 2 AUTOClean - Cleaning the main filter (only versions with AutoClean) To maintain a constant suction power when extracting fine dust, you can adjust the frequency of the automatic [1-7] cleaning system in infinite variables using the rotary knob. Always use the automatic cleaning system in combination with a disposal bag (in line with dust class 'L' requirements). Before performing wet extraction tasks or working with a filter bag, set the [17] rotary knob to position 0. X Set the automatic cleaning function to the highest setting when [1-7] extracting large quantities of dust. Manual cleaning If the suction power decreases, cleaning can be started manually by turning the switch [1-8] to the AC symbol positioned on either side of the switch. We recommend cleaning the main filter completely if severely clogged: X Set the suction power adjuster [1-9] to the maximum setting. : 497926), the filter can be cleaned fully without removing the connected electric power tools. In intensive applications that generate adherent dust, it may be necessary to clean the filter element mechanically under certain circumstances (extract). 3 Special features of the CTL 36 E AC- LHS To use the mobile dust extractor in combination with the PLANEX: X Use the accompanying kink-resistant suction hose D 36 mm x 3. X Insert the accompanying CT-VS closing slide between the intake opening [1-1] and the suction hose. x Fit the tool holder as described in the accompanying installation instructions. X When performing extraction work with the PLANEX, always use disposal bags to prevent dust from escaping into the surrounding area. The dust extractor stops automatically when the maximum level is reached. Escaping foam and fluids X Switch off the machine immediately and empty the dirt trap. 6 The antistatic system Friction inside the extraction hose causes static electricity to develop during extraction. [. . . ] 2 Emptying the dust container The dust container [2-3] can be emptied once the top section has been removed. X After extracting fluids, clean the fill level sensors [10-1] regularly with a soft cloth and inspect for damage. Use only original Festool accessories and Festool consumable material intended for this machine because these components are designed specifically for the machine. Using accessories and consumable material from other suppliers will most likely affect the We offer a warranty for material and production defects for all our tools in accordance with the locally applicable legal provisions, but for a minimum of 12 months. [. . . ]