User manual FESTOOL CS 70 KA ASSEMBLY

[. . . ] If used with the sliding table CS 70 ST, only the stop ruler (Order No. [. . . ] 12) into the end piece and pull the tape measure through the upper groove (1. To prevent the tape measure from making contact with the saw blade, this starts at 30 mm. The gap between the front edge of the profile rail and the rim of the saw blade thus has to be adjusted to 30 mm as follows: pull the tape measure (4. Set the mitre fence to a right-angled cut and push the profile rail until the end of the tape measure touches the sides of the saw blade cutting edges (4. 5) and lock the tape measure so that its end is flush with the front edge of the profile rail. 2 Setting the adjustable stop The adjustable stop can be set with no play in the groove with the two screws (5. Fit the adjustable stop and tighten the two screws until this can be moved with no play, but still easily, in the groove. 3) on the other side of the adjustable stop if required with the screw (5. [. . . ] Fasten the base support to the lower groove of the stop ruler with the rotary knob (6. [. . . ]