User manual FESTOOL C15 LI SPARE PARTS LIST

[. . . ] Carrying the power tool with your finger at the on/off switch, or inserting the battery when the power tool is switched on, can result in accidents. Take care when drilling into walls as there is a danger of rupturing concealed gas/water pipes or cutting through power cables. Even after disconnection from the Mains, there is still a high capacitor voltage inside the charger. ­ Make sure that metal objects (such as metal chips) do not collect in the battery pack retaining slots or enter the machine through the air vent slits (danger of short circuit). [. . . ] l The switch-over function only works if the machine is switched off. X Adjust the torque accordingly at the torque [1-1] wheel: Position 1 = low torque Position 25 = high torque The machine switches off when the preset torque is reached and an acoustic signal sounds. The machine only continues running when the on/off switch is [1-9] released and then pressed again. 4 Drilling Adjust the switch [1-7] so that its marking faces the drilling symbol [1-5]. Tool has sharp edges and can cause cutting injuries during a tool change. 4 Eccentric attachment DD-ES [7] The eccentric attachment (in part, additional equipment) permits screwdriving near edges with bits according to DIN 3126. 5 Tool holder in the drill spindle [8] Bits can be inserted directly in the hexagon socket holder on the drill spindle to shorten and reduce the weight of the machine. 1 On/Off switch [1-9] Press = ON, release = OFF L The speed of the machine depends on how far the on/off switch is pressed in. The LED lamp [1-3] lights up when the on/off switch [1-9] is pressed and lights up the working area. 3 Acoustic warning signal Acoustic warning signals sound and the machine switches off in the following operating states: Risk of injury, electric shock X Always disconnect the battery pack before any type of work on the machine!X Once the battery pack has cooled, perform a functional check using the charger. Use only original Festool accessories and Festool consumable material intended for this machine because these components are designed specifically for the machine. Using accessories and consumable material from other suppliers will most likely affect the quality of your working results and limit any warranty claims. Machine wear or your own personal workload may increase depending on the application. Protect yourself and your machine, and preserve your warranty claims by always using original Festool accessories and Festool consumable material!The order numbers of the accessories and tools can be found in the Festool catalogue or on the Internet under "www. Observe the following instructions: ­ Keep the air slits on the machine and the charger free and clean to ensure adequate cooling. ⭠Keep the contacts on the machine , charger and battery pack clean. Information on battery packs ­ Where possible, store the battery pack in a cool, dry place at a temperature between 5 °C and 25 °C. ­ Battery packs are most efficient at temperatures between 20 °C and 30 °C. ⭠Protect the battery pack from moisture , water and heat. ­ Significantly shorter operating times after each charge indicate that the battery pack is worn and should be replaced with a new one. [. . . ] Complaints can only be accepted if the tool is returned while still assembled to the supplier or an authorised Festool Customer Service workshop. Keep the operating manual, safety instructions, spare parts list and purchase receipt in a safe place. Otherwise the current warranty conditions of the manufacturer shall apply. Note Due to continuous research and development work, we reserve the right to make changes to the technical content of this documentation. [. . . ]