User manual FESTOOL 0F 1400 EBQ

[. . . ] Aluminium and plasterboard can also be processed with corresponding cutters such as are listed in the Festool catalogues. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The term , , power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 2 Tool-specific safety rules - Hold power tool by insulated gripping surfaces, because the cutter may contact its own cord. [. . . ] 3 How to change the clamping collet Clamping collets are available for following shank diameters: 6. - Insert a new clamping collet with nut into the spindle and slightly tighten the nut. - Press the stop cylinder against one of the three sensing stops of the pivoted turret stop (1. The individual height of each sensing stop can be adjusted with a screwdriver: Sensing stop min. If the base position is incorrect, this can be adjusted with the screw (1. B) Setting the milling depth The desired milling depth can be set either with the quick depth adjustment or with the fine depth adjustment. Turn the adjusting wheel to the next mark on the scale to adjust the milling depth by 0. - Fit the extractor hood to the router base by first inserting the two tenons (3. 2) on the router base, then place the extractor hood on the router base and close the lever (3. For optimised dust extraction, the recess with the rotating segment must be closed during work. A Festool dust extractor with an extractor hose diameter of 36 mm or 27 mm (36 mm recommended due to the reduced risk of clogging) can be connected to the extractor connector (3. KSF-OF chip catcher Using the KSF-OF chip catcher (sometimes included in the scope of delivery), the efficiency of the extraction can be increased when routing edges. The hood can be cut off along the grooves using a hacksaw and can thus be reduced in size. The chip catcher can then be used for interior radiuses up to a minimum radius of 40 mm. 6 Working with the machine Always secure the workpiece in such a manner that it cannot move while being sawed. The machine must always be held with both hands by the designated handles (1. always advance the router in the direction opposite to the direction of rotation of the cutter (counter-routing)!When routing (ensure feed direction of power tool is the same as cutting direction of tool, Fig. Aluminium processing When processing aluminium, the following measures must be taken for safety reasons: - Pre-connect a residual current circuit-breaker (FI, PRCD). 2 Freehand routing Freehand routing is the method normally used for lettering or shapes, and for routing edges using cutters with a guide pin or ring. 2) supplied can be used for routing parallel to the edge of the workpiece. - Insert the guide rods into the grooves on the router base to the required distance and secure them by turning the rotary knob (4. [. . . ] In the EU countries, the warranty period is 24 months (an invoice or delivery note is required as proof of purchase). Damage resulting from, in particular, normal wear and tear, overloading, improper handling, or caused by the user or other damage caused by not following the operating instructions, or any fault acknowledged at the time of purchase, is not covered by the warranty. Complaints will only be acknowledged if the equipment has not been dismantled before being sent back to the suppliers or to an authorised Festool customer support workshop. Store the operating instructions, safety notes, spare parts list and proof of purchase in a safe place. [. . . ]