User manual FENDER PX 2216D

[. . . ] Standard 1/4- inch phone jacks are used for ease of connection or extension of the footswitch to remote pedal boards. The PREAMP OUT & POWER AMP IN jacks can be used as an effects loop or as Send and Return points while slaving multiple amps together or for direct connection to recording and sound reinforcement mixers. The possibilities are endless (eg: by inserting a Chorus pedal between the PREAMP OUT of one amp and the POWER AMP IN of another, a true stereo image effect can be achieved). [. . . ] Last but definitely not least, the Fender PX 2216D packs a new power amp that is based on a radically underdamped design that interacts with the speaker in much the same way as a tube amplifier does, producing sparkle and punch with an increase in apparent loudness and power that defies comparison to other similarly rated units Also included is a sophisticated, transparent protection scheme designed to completely prevent amplifier failure due to bad speaker cords or incorrectly connected speaker jacks. The selection of a Fender amplifier will reward you with years of quality music in a wide range of controlled sounds. This manual is designed to familiarize you with the equipment and to acquaint you with its many fine features. Read it carefully so that you will benefit from all the features as soon as you start using the amplifier. The built-in quality of a Fender amplifier is the result of over three and a half decades of dedication in the combined skills of research and development by our engineers and musicians. WARNING: TO REDUCE THE RISK OF FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS AMPLIFIER TO RAIN OR MOISTURE. NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED PERSONNEL ONLY. PX 2216D FRONT PANEL FUNCTIONS A. INPUT I- A high impedance, high sensitivity plug-in connection for instruments. FOOTSWITCH- Plug-in connection for a remote footswitch to switch between NORMAL and DRIVE channels and to turn the REVERB on and OFF. NOTE: Any good quality patch cord will work with the remote footswitch; however, a speaker grade cord is preferable to a coax guitar cord when it's available. 0. PREAMP OUT- This jack provides an unbalanced output signal from the preamp. This jack can be used with the POWER AMP IN jack (item R) as a patch point for effects. This is useful when using effects, or when the the PX 2216D is used as a slave amplifier. HEADPHONE- This jack provides as output to standard stereo or mono headphones for private listening. CAUTION: Prolonged listening at high levels may be hazardous to your hearing!When the switch is in off position, the amplifier is completely shut down. PX 2216D REAR PANEL FEATURES LINE CORD This amplifier is equipped with a grounding type supply cord to reduce the possibility of shock hazard. [. . . ] When the switch is in off position, the amplifier is completely shut down. PX 2216D REAR PANEL FEATURES LINE CORD This amplifier is equipped with a grounding type supply cord to reduce the possibility of shock hazard. WARNING: THIS EQUIPMENT MUST BE EARTH GROUNDED VINYL CARE The exclusive Fender vinyl covering on your cabinet has been especially designed for years of lasting beauty. A very light, soapy solution on a sponge may be used to remove dirt and residue that may accumulate in the grain. [. . . ]