User manual FENDER PRINCETON STEREO CHORUS

[. . . ] At high LIMITER and GAIN settings a very dynamic effect can be achieved by varying pick attack. High output pickups with the instrument tone control turned down can achieve reverse envelope, backwards tape effects and many other sounds. ) The extended range three band equalization circuitry is post overdrive and can be used to further modify the overall sound of the amp. In addition to convenience features like All Front Panel Mounted Controls and Jacks, the PRINCETON CHORUS features a detachable footswitch for selecting the Overdrive Mode and for activating the stereo chorus circuitry. [. . . ] OVERDRIVE INDICATOR-This LED is illuminated when in the overdrive mode. PRESENCE -Adjusts the amount of boost or cut in the upper high frequency range while in the OVERDRIVE mode. This control occurs post preamp distortion and is useful in adjusting the distortion characteristic from brash, to smooth. A lower setting will introduce a subtle yet distinct effect whereas a higher setting will create a more dramatic effect. RATE and DEPTH controls set midway or higher, a variety of vibrato/tremolo type effects can be achieved. CHORUS INDICATOR-This LED is illuminated when the stereo chorus is active. The intensity of the LED is modulated by the chorus sweep LFO to give a visual indication of the sweep rate. FOOTSWITCH- Plug-in connection for remote footswitch to activate the OVERDRIVE mode and to switch the stereo CHORUS on and off. NOTE: Any good quality patch cord will work with the remote footswitch, however a speaker grade cord is preferable to a coax guitar cord when it's available. T. EFFECTS LOOP MONO SEND-This jack provides an unbalanced mono output signal from the preamp at a point before the internal effects circuits (REVERB & CHORUS). The MONO SEND can also be used to feed recording and sound reinforcement mixers a dry signal. STEREO SEND jack. ) Additionally this output can be used to drive another PRINCETON CHORUS as a slave amp. This is done by connecting a standard guitar cord from the MONO SEND jack of the master amplifier to the MONO RETURN jack of the slave. EFFECTS LOOP MONO RETURN -This unbalanced jack inputs signal to the stereo chorus and reverb generating circuitry, which drives the stereo power amp section. This is useful when using the Mono Effect Loop option or when using the PRINCETON CHORUS as a slave amplifier for a mono signal source. The REVERB & CHORUS are active in the slave so that a stereo image will be generated if the chorus is used. [. . . ] VINYL CARE- The exclusive Fender vinyl covering on your cabinet has been especially designed for years of lasting beauty. A very light soapy solution on a sponge may be used to remove dirt and residue that may accumulate in the grain. Be careful not to let any liquid come in contact with operating surfaces. [. . . ]