User manual FENDER MX-METERBRIDGE

[. . . ] Because loudspeaker enclosures placed on the Passport tripod speaker stand could be damaged or cause bodily harm if they fall, please read through these instructions and heed all caution and safety warnings. [. . . ] 4 Turn tripod upright and slide leg fitting to adjust the width of the leg spread until the center pole is approximately 1/4" (64 mm) from the floor. This will ensure the Passport tripod speaker stand is at its maximum footprint (Using a smaller footprint will adversely affect the stability of the unit). Remember to secure all wires coming from the Passport tripod speaker stand for reasons of both safety and good presentation (loose wires can be tripped on and give a cluttered, unprofessional appearance). IMPORTANT When setting up your Passport tripod speaker stand, make sure it is placed on a dry, flat and secure surface. Do not extend the center pole more than 36" (91. 4 cm) above the locking collar support. Re-tighten handknob and check the stability of the unit at the desired height setting. Tighten collar handknob REMEMBER . . . 3 Turn tripod upside down and pivot legs out. Check to ensure that all handknobs are secure when supporting equipment. [. . . ] Check to ensure that all handknobs are secure when supporting equipment. [. . . ]