User manual FENDER MX 5224

[. . . ] Enclosed in a quasi-trapezoidal floor monitor style cabinet, the PowerStage Xpander 100 includes a 100 watt power amp, a power supply and a fullrange coaxial speaker system. With three angles of orientation, your PowerStage Xpander 100 is ideally suited for use as either a small PA system or to compliment your monitoring needs. WARNING: - TO REDUCE THE RISK OF FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. [. . . ] - NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED PERSONAL ONLY. LINE INPUT - A 1/4 inch TRS unbalanced input jack designed to receive a line level signal from the PowerStage 100. Before plugging or unplugging any cord into the line input, make sure the PowerStage Xpander 100 is off. POWER LED - This LED illuminates when the PowerStage Xpander 100 is on. D B. This is a grounding type supply cord to reduce the possibility of shock hazard. When the switch is in the OFF position, the PowerStage Xpander 100 is completely shut down. SETTING UP THE PS XPANDER 100 Before using the PowerStage Xpander 100, please read and follow the steps listed below: 1. Plug the female end of the supply cord into the supply cord jack (item B previous page) of the PowerStage Xpander 100. Be sure to use properly maintained cords and cables with the PowerStage Xpander 100. TROUBLESHOOTING If the PowerStage 100 is set up but does not function, please check the following items: CARPET COVERING CARE The PowerStage Xpander 100 is covered in a tough, soil resistant synthetic indoor/outdoor carpet for long life and lasting good looks. To clean the carpeted cabinet, use a brush to wipe away any smudges or dirt. For stubborn stains, a sponge with a light soapy solution may be used. Avoid spilling liquids on the operating surface, heat sink, grille, volume and tone controls, switches and speakers. ALWAYS unplug the PowerStage Xpander 100 before cleaning it and wait until it has dried before plugging in the PowerStage Xpander 100. · Is the PowerStage Xpander 100 power cord properly plugged into an electrical outlet?· Is the power cord properly plugged into the PowerStage Xpander 100's supply cord jack? [. . . ] · Is the power cord properly plugged into the PowerStage Xpander 100's supply cord jack?· Are the volume control knobs on the Power Stage 100 turned above the MIN position? [. . . ]