User manual FENDER KXR 60

[. . . ] system, suitable for almost any musical instrument requiring full-range sound reinforcement. This makes the KXR 60 ideal for amplifying electronic keyboards, acoustic/electric guitar, electric violin or voice. Compact packaging and medium level output power make the KXR 60 the perfect full-range instrument amplifier for rehearsal, studio or small club performances. [. . . ] This channel is muted when nothing is plugged into its input, and thus will contribute no additional noise to the amplifier output when left unused. Both channels may be used simultaneously, however Channel 1 should be used first if only one input is needed. EQUALIZER- The equalizer allows precise adjustments of the tonal characteristics of the amplifier. Each control provides a 12 dB boost or cut to bands of frequencies centered about 100, 338, 1188, and 4000 Hz. REVERB CONTROL- This control adjusts the amount of reverb to be mixed with the dry signal. EFFECTS SEND JACK- This jack provides an unbalanced output signal from the preamp. This output can be used with the Effects Return jack (item G) as a patch point for mono effects devices. The Effects Send is connected to the input of the effect (digital delay or other effects device) and the output of the effect is connected to the Effects Return jack (Item G). The Effects Send can also be used to provide a signal to a recording or sound reinforcement mixer. In addition, this output can be used to drive another KXR 60 used as a slave amp. This is done by connecting a standard guitar cord from the Effects Send jack of the master amp to the Effects Return jack of the slave amp. E. F. C. G. EFFECTS RETURN JACK- This balanced jack inputs signal to the Master Volume control which drives the power amp section. This jack is useful with the effects loop feature, or when using the KXR 60 as a slave amp. MASTER VOLUME CONTROL- This control adjusts the level of the signal coming out of the preamplifier section. [. . . ] UNPLUG THE POWER CORD BEFORE CLEANING. TROUBLESHOOTER`S CHECKLIST If the amplifier is set up but does not function, check the following items: · Is the amplifier power cord plugged into an electrical outlet ?(Eliminate any effect pedals and try another instrument cord. ) If after checking all of the above, and the system is still not performing correctly, consult your FENDER Service Dealer. ® KXR 60 BLOCK DIAGRAM KXR 60 SPECIFICATIONS Part Number: 120V Version: Aust. Version: UK Version: 230V Version: 100V Version: PR 299 100V Version: 120V Version: 230V Version: 240V Version: 100VAC, 50/60Hz, 180W 120VAC, 60Hz, 180W 230VAC, 50Hz, 180W 240VAC, 50Hz, 180W 022-8500-000 022-8530-000 022-8540-000 022-8560-000 022-8570-000 THIS EQUIPMENT CONFORMS TO THE FOLLOWING DIRECTIVES : EMC 89/336/EEC AND LV 73/23/EEC Type Specification: Power Requirements: POWER AMPLIFIER SECTION: Power output: Rated load impedance: Distortion at 50 watts: 50 W R. M. S. [. . . ]