User manual FENDER KXR 200

[. . . ] The KXR 200 is also equipped with a master section which contains a master volume control, an effect return control, a reverb return control, an effects send jack, an effects return jack, and a line-out portion comprising of a 1/4 inch and XLR jacks. The KXR 200 keyboard amplifier was designed to give years of reliable service under all conditions and is equipped with a unique implementation of our exclusive, defeatable DELTACOMPTM compressor system. When DELTACOMPTM is engaged, it is practically impossible to cause the power amplifier to clip (distort). [. . . ] All the controls and jacks operate in the same manner as those in channel 1. When not in use, it is best to turn the channel volume, the effects send and the reverb send controls all the way down to avoid any amplification of unwanted noise. Likewise, when not in use, the equalizer sections should be kept flat ( i. e. CHANNEL 4 - This channel operates in the same manner as the other three channels, but with the addition of a few extra features: The XLR jack and an extra band in the equalizer section. With the vocalist in mind, the balanced, low impedance XLR jack provides a suitable connection for a microphone. Furthermore, the four-band equalizer was designed around the D. F I J K L M CHANNEL 2 LOW 0 MASTER HIGH 0 5 ON 5 MID 0 SEND EFFECTS REVERB 5 VOLUME 5 5 RETURN EFFECTS REVERB -12 +12 -12 +12 -12 +12 0 10 0 10 0 10 0 10 0 10 ON OFF DELTACOMPTM CHANNEL 4 VOLUME 5 LOW 0 LOW MID 0 HIGH MID 0 HIGH 0 5 SEND EFFECTS REVERB 5 POWER 0 10 -12 +12 -12 +12 -12 +12 -12 +12 0 10 0 10 KEYBOARD EXTENDED RANGE Two hundred H N O vocal frequencies. With each control providing 12dB of boost or cut, and centered about 125, 320, 1000 and 3200 Hz. MASTER VOLUME CONTROL - This control adjusts the level of the signal coming out of the preamplifier section. This control is used in conjunction with the Channel Volume controls to set the overall sound level of the amplifier. In order to maximize headroom and minimize noise, instruments with low-level output will require a high Channel Volume setting and a low Master Volume setting, while other instruments may require a lower Channel Volume and higher Master Volume setting. It is recommended that the Master Volume control be set as high as possible for maximum DELTACOMPTM compressor range. EFFECTS RETURN CONTROL - This control adjusts the level of the signal coming into the power amplifier section from external effect devices. If not in use, it is recommended that this control be set at 0 to avoid amplification of any unwanted signal. REVERB RETURN CONTROL - This control adjusts the level of the reverb signal coming into the power amplifier from the reverb bus. The input to the reverb circuitry is the sum of the individual channel reverbs. When not in use, it is recommended that this control be set at 0 to avoid amplification of any unwanted signal. L. PEAK LED INDICATOR - This LED comes on when excessive signal levels are being sent to the power amplifier. [. . . ] Note that the layout of the insert jacks on the back panel is the mirror image of the channels layout on the front panel. POWER CORD - This amplifier is equipped with a grounding type supply cord to reduce the possibility of shock hazard. The line cord should be connected to a suitable power source, in accordance with the voltage and frequency as shown by the power rating on the rear panel. NOTE: DO NOT BLOCK THE AIR FLOW TO THE REAR PANEL; FOR EXAMPLE, BY BACKING THE AMPLIFIER UP AGAINST A WALL. [. . . ]