User manual FENDER KXR 100

[. . . ] The EFFECTS SEND can also be used to connect your KXR 100 directly to a recording console or sound reinforcement mixer. The HEADPHONE jack automatically mutes the speaker while driving stereo or mono headphones for private practice sessions. [. . . ] These channels are muted when nothing is plugged into their inputs, and thus will contribute no additional residual noise to the amplifier output when left unused. All three channels may be used simultaneously, however Channel 1 should be used first if only one input is needed. Equalizer- The equalizer allows precise adjustments of the tonal characteristics of the amplifier. Each control provides a 12 dB boost or cut to bands of frequencies centered about 100, 338, 1588, and 4000 Hz. Reverb control- This control adjusts the amount of reverb to be mixed with the dry signal. Effects Send jack- This jack provides an unbalanced output signal from the preamp. This output can be used with the Effects Return jack (item H) as a patch point for mono effects devices. The Effects Send is connected to the input of the effect (digital delay or other effects device) and the output of the effect is connected to the Effects Return jack (item H). The Effects Send can also be used to provide a signal to a recording or sound reinforcement mixer. In addition, this output can be used to drive another KXR 100 as a slave amp. This is done by connecting a standard guitar cord from the Effects Send jack of the master amp to the Effects Return jack of the slave amp. Effects Return jack- This balanced jack inputs signal to the Master Volume control, which drives the power amp section. This jack is useful with the effects loop feature, or when using the KXR 100 as a slave amp. Master Volume control- This control adjusts the level of the signal coming out of the preamplifier section. [. . . ] Be careful not to let any liquid come in contact with the operating surfaces. UNPLUG THE POWER CORD BEFORE CLEANING. Troubleshooters Checklist If the amp is set up but does not function, check the following items: - Is the amp power cord plugged into an electrical outlet? [. . . ]