User manual FENDER ERIC CLAPTON STRATOCASTER

[. . . ] WARNING: To prevent damage, fire or shock hazard, do not expose this unit to rain or moisture. Unplug the power supply cord before cleaning the unit exterior (use a damp cloth only). Wait until the unit is completely dry before reconnecting it to power. [. . . ] Wait until the unit is completely dry before reconnecting it to power. 25 cm)of unobstructed air space behind the unit to allow for proper ventilation and cooling of the unit. This product should be located away from heat sources such as radiators, heat registers, or other products that produce heat. This product may be equipped with a polarized plug (one blade wider than the other). If you are unable to insert the plug into the outlet, contact an electrician to replace your obsolete outlet. This product should only be used with a cart or stand that is recommended by the manufacturer. The power supply cord of this product should be unplugged from the outlet when left unused for a long period of time, or during electrical storms. Fender®/Groove TubesTM GT-6L6 GE The output tubes in your new Vibroverb amplifier are performance matched and labeled as a color-coded pair. When replacing these tubes, we recommend selecting new tubes that have the same red, white or blue color labels as the originals. FUSE - Replacement fuses must match the type and rating specified on the rear panel of your amplifier. IEC POWER SOCKET - The power line cord must be connected to a grounded AC receptacle in compliance with the voltage and frequency ratings specified on the rear panel of your amplifier. STANDBY Use STANDBY instead of switching POWER OFF during short breaks to avoid tube warm-up delay and related tube wear. Use STANDBY for 30 seconds when switching POWER ON to extend tube life span. This jack automatically adjusts the amplifier to accommodate an additional 8­ohm speaker when one 8­ohm speaker is already plugged into the main SPKR. [. . . ] STANDBY Use STANDBY instead of switching POWER OFF during short breaks to avoid tube warm-up delay and related tube wear. Use STANDBY for 30 seconds when switching POWER ON to extend tube life span. This jack automatically adjusts the amplifier to accommodate an additional 8­ohm speaker when one 8­ohm speaker is already plugged into the main SPKR. [. . . ]