User manual FENDER ELITE PRECISION BASS I

[. . . ] Only connect the power supply cord to an earth grounded AC receptacle in accordance with the voltage and frequency ratings listed under INPUT POWER on the rear panel of this product. WARNING: To prevent damage, fire or shock hazard, do not expose this unit to rain or moisture. [. . . ] Unplug the power supply cord before cleaning the unit exterior (use a damp cloth only). Wait until the unit is completely dry before reconnecting it to power. 25 cm)of unobstructed air space behind the unit to allow for proper ventilation and cooling of the unit. This product should be located away from heat sources such as radiators, heat registers, or other products that produce heat. This product may be equipped with a polarized plug (one blade wider than the other). STANDBY - In standby mode, power is supplied only to the tube filaments to keep them warm and ready to operate. Use standby during short breaks to eliminate warm-up time and extend the life of the tubes. Speakers (internal or external) must always be connected here while operating the unit. *** NOTE: The amp is optimized for a 2 ohm speaker load, which is the rating of the internal speaker configuration. If a speaker load other than 2 ohms is used, the amplifier will distort before reaching maximum output, and the life of the tubes will be reduced. [. . . ] *** NOTE: The amp is optimized for a 2 ohm speaker load, which is the rating of the internal speaker configuration. If a speaker load other than 2 ohms is used, the amplifier will distort before reaching maximum output, and the life of the tubes will be reduced. [. . . ]