User manual FENDER ELITE GUITARS

[. . . ] [. . . ] Designed to complement the Fender® AcoustasonicTM Ultralight amplifier, the Ultralight speaker cabinet is constructed from quality Italian poplar plywood. Please read these instructions and your amplifier manual before making connections. SPECIFICATIONS PART NUMBER SPEAKERS 2271700000 Two 8" (20. 3 cm) drivers with 2" (5. 1 cm) voice coils and Neodymium magnets; Two 1" (2. 5 cm) soft dome tweeters with Neodymium magnets CROSSOVER 3kHz, 12dB/octave low-pass filter, 18dB/octave high-pass filter, using metallized polyester film capacitors and low loss inductors 5/8" (1. 6 cm) Italian poplar plywood 91 dB, 1 watt - 1 meter 125 watts per side 4 ohms per side 4-Pole Speakon® connector Ultralight Connections To connect the AcoustasonicTM Ultralight speaker to an Ultralight amplifier, use the Speakon® cable included with the amplifier. Pull the connector out from the input socket. ENCLOSURE VOLUME VB = 0. 43 ft3 (12 L) per side Height: 15 in (38. 1 cm) Width: 20. 25 in (51. 4 cm) Depth: 10 in (25. 4 cm) WEIGHT 22 lb (10. 0 kg) Non-Speakon® Connections If your amplifier does not have a Speakon® speaker output, you will need the appropriate speaker cable or adapter to connect the AcoustasonicTM Ultralight loudspeaker. Speaker cable should be 4-conductor, 18­gauge minimum with the Speakon® connector wired: 1+ 1­ 2+ 2­ pin pin pin pin = = = = Right [+] Right [­] Left [+] Left [­] Product specifications are subject to change without notice. A PRODUCT OF: FENDER MUSICAL INSTRUMENTS CORPORATION CORONA, CALIFORNIA USA Fender® and AcoustasonicTM are trademarks of FMIC. [. . . ] [. . . ]