User manual FENDER BRONCO GUITAR

[. . . ] Only connect the power supply cord to an earth grounded AC receptacle in accordance with the voltage and frequency ratings listed under INPUT POWER on the rear panel of this product. WARNING: To prevent damage, fire or shock hazard, do not expose this unit to rain or moisture. [. . . ] Unplug the power supply cord before cleaning the unit exterior (use a damp cloth only). Wait until the unit is completely dry before reconnecting it to power. 25 cm) of unobstructed air space behind the unit to allow for proper ventilation and cooling of the unit. This product should be located away from heat sources such as radiators, heat registers, or other products that produce heat. This product may be equipped with a polarized plug (one blade wider than the other). If you are unable to insert the plug into the outlet, contact an electrician to replace your obsolete outlet. STANDBY - Use STANDBY instead of switching the power off during short breaks to eliminate the tube warm-up delay upon returning to play. POWER CORD - Connect the power cord in accordance with the voltage and frequency ratings listed on the rear panel of the unit. If the unit repeatedly blows fuses, have the unit tested at an authorized Fender® Service Center. MAIN SPEAKER - One of the following speaker load configurations (internal or external) must always be connected as shown below, when the unit is on: DeVille 410 DeVille 212 EXTERNAL SPEAKER - This jack is wired in parallel with the main speaker jack and must only be used with something connected to the main speaker jack as shown in the MAIN SPEAKER {V} description above. FENDER®/GROOVE TUBESTM GT6L6B - The output tubes in your new Hot RodTM amplifier are performance matched and labeled as a color-coded pair. When replacing these tubes, we recommend selecting new tubes that have the same red, white or blue color labels as the originals. [. . . ] FENDER®/GROOVE TUBESTM GT6L6B - The output tubes in your new Hot RodTM amplifier are performance matched and labeled as a color-coded pair. When replacing these tubes, we recommend selecting new tubes that have the same red, white or blue color labels as the originals. [. . . ]