User manual FENDER 63 VIBROVERB

[. . . ] We resisted the temptation to "improve" the amp with features found on later models like master volume, effects loop or channel switching. In order to improve reliability, a solid state rectifier was used rather than a 5AR4 tube. Since the `63 VIBROVERB uses a solid state rectifier, there is one less tube and tube socket than an original VIBROVERB. [. . . ] REVERB CONTROL - Adjusts the amount of reverberated signal that is mixed in with the original, dry signal. Turning the control full counter-clockwise turns the REVERB feature off. The REVERB feature can also be E. BASS CONTROL - Adjusts the amount of low frequency boost or cut in the NORMAL CHANNEL. turned on and off using the footswitch. Note that the REVERB feature does not affect the NORMAL CHANNEL. F, G. The BRIGHT CHANNEL provides extra treble boost, especially at low volume settings. The BRIGHT CHANNEL is affected by both the REVERB and VIBRATO features. VIBRATO SPEED CONTROL - Adjusts the speed of the VIBRATO feature. M. VIBRATO INTENSITY CONTROL - Adjusts the intensity of the VIBRATO feature. Turning the control full counter-clockwise turns the VIBRATO feature off. The VIBRATO feature can also be turned on and off using the footswitch. N. PILOT LAMP - When the lamp is illuminated, the `63 VIBROVERB is receiving power. Should the lamp burn out, turn off the power, unscrew the red jewel and replace the lamp with a type T47 light bulb. `63 VIBROVERB FOOTSWITCH FUNCTIONS A. VIBRATO SWITCH - Push on, push off switch that turns the VIBRATO feature on and off. B. REVERB SWITCH - Push on, push off switch that turns the REVERB feature on and off. VR IE BV 270W `63 VIBROVERB REAR PANEL FUNCTIONS A. FUSE - The fuse is in the AC supply of the amplifier and will help to protect the amplifier and operator in the event of an electrical fault. [. . . ] Fender's Special Design Tubes provide optimum performance in this amplifier. Tube location is printed on the tube label, inside the cabinet. operating surfaces. DO NOT have the amplifier plugged into a power outlet when cleaning. TROUBLESHOOTER`S CHECKLIST If the amp is set up but does not function, check the following items: · · · · · · · · Is the amp power cord properly plugged into an electrical outlet? [. . . ]