User manual FENDER 3014 POWER AMPLIFIER

[. . . ] 25 cm) of unobstructed air space behind the unit to allow for proper ventilation and cooling of the unit. This product should be located away from heat sources such as radiators, heat registers, or other products that produce heat. This product may be equipped with a polarized plug (one blade wider than the other). [. . . ] This product may be equipped with a polarized plug (one blade wider than the other). If you are unable to insert the plug into the outlet, contact an electrician to replace your obsolete outlet. This product should only be used with a cart or stand that is recommended by the manufacturer. The power supply cord of this product should be unplugged from the outlet when left unused for a long period of time, or during electrical storms. This product should be serviced by qualified service personnel when: the power supply cord or the plug has been damaged; or objects have fallen, or liquid has been spilled onto the product; or the product has been exposed to rain; or the product does not appear to operate normally or exhibits a marked change in performance; or the product has been dropped, or the enclosure damaged. Do not drip nor splash liquids, nor place liquid filled containers on the unit. cAUTION: No user serviceable parts inside , refer servicing to qualified personnel only. Fender® amplifiers and loudspeaker systems are capable of producing very high sound pressure levels which may cause temporary or permanent hearing damage. This jack is wired in parallel with the INTERNAL SPEAKER JACK {M} and affects the speaker impedance load. To use the external speaker output, first disconnect the internal speaker. Then connect a 16 speaker load (minimum) to the internal speaker jack and another 16 speaker load (minimum) the external speaker jack. A speaker must always be connected at this jack when the amplifier is ON. A speaker impedance load of 8 should be used to avoid distortion or damage to the amplifier. When using only the internal speaker jack, a speaker impedance load Your new Fender® amplifier comes equipped with the highest quality tubes available, sourced from various manufacturers all over the world. Because of occasional irregularities in supply, the specific tube type used in each amplifier is subject to change without notice. When replacing output tubes, please note the specific tube markings on the original tubes factory supplied with your amplifier. [. . . ] When using only the internal speaker jack, a speaker impedance load Your new Fender® amplifier comes equipped with the highest quality tubes available, sourced from various manufacturers all over the world. Because of occasional irregularities in supply, the specific tube type used in each amplifier is subject to change without notice. When replacing output tubes, please note the specific tube markings on the original tubes factory supplied with your amplifier. [. . . ]