User manual FENDER 25TH ANNIVERSARY STRATOCASTER

[. . . ] Only connect the power supply cord to an earth grounded AC receptacle in accordance with the voltage and frequency ratings listed under INPUT POWER on the rear panel of this product. WARNING: To prevent damage, fire or shock hazard, do not expose this unit to rain or moisture. [. . . ] WARNING: To prevent damage, fire or shock hazard, do not expose this unit to rain or moisture. Unplug the power supply cord before cleaning the unit exterior (use a damp cloth only). Wait until the unit is completely dry before reconnecting it to power. 25 cm) of unobstructed air space around the unit to allow for proper ventilation and cooling of the unit; do not block any vents in the unit chassis. Also, if rack mounted, remove the rack enclosure front and rear covers and leave empty one full rack space above the unit. This product should be located away from heat sources such as radiators, heat registers, or other products that produce heat. Professional XLR line output with Level control, Ground Lift, and Pre-Post EQ switch · effects loop and Tuner Output with Mute · Limiter with On-Off button--prevents distortion when you play hard · INPUT PAD - Reduces input sensitivity to allow cleaner response with high-output guitars: NORMAL--Full input sensitivity ­10dB PAD--Lower input sensitivity C. NOTE: Your Steel King amplifier is designed to sound great with the tone controls {D­G} in the center or "12 o'clock" position D. EQ TILT - Can be used as a simple tone control or to compensate for poor room acoustics: HI provides treble emphasis--useful in "dull" sounding environments (carpet/drapes) LO provides bass emphasis--useful in "sharp" sounding environments (cement/tile) E. Activate the LIMITER or reduce MASTER {J} if you hear distortion when this LED is on. GROUND LIFT - Disconnects the LINE OUT {Q} ground connection (pin-1) which may reduce hum noise in some situations. PRE/POST EQ - Supplies the LINE OUT jack with the signal either before or after it is processed by the amplifier's tone and equalization circuits. [. . . ] GROUND LIFT - Disconnects the LINE OUT {Q} ground connection (pin-1) which may reduce hum noise in some situations. PRE/POST EQ - Supplies the LINE OUT jack with the signal either before or after it is processed by the amplifier's tone and equalization circuits. [. . . ]