User manual FENDER 2244

[. . . ] magnet and paper coil former (P/N 050543) Bill Schultz Chairman Fender Musical Instruments Corporation DIMENSIONS Height: 8. 75 in Width: 7. 75 in Depth: 6. 75 in 13 lbs 22. 3 cm 19. 7 cm 17. 2 cm 5. 9 kg WEIGHT Amp CanTM is a trademark of FMIC. Fender®, Tone-Master® and Twin Reverb® are registered trademarks of FMIC. Product specifications are subject to change without notice. 7 BATTERY CARE, Cont. IMPORTANT: DO NOT DISPOSE OF THE BATTERY IN THE GARBAGE. For proper disposal of the lead-acid battery, it should be taken to a lead-acid battery recycle and disposal center, such as an automobile service center, to avoid environmental contamination. [. . . ] As a final note, playing your Amp Can with the charge adapter attached and plugged in will not damage the unit, however, a slight hum will occur. Additionally, playing your Amp Can with the charge adapter attached will significantly increase playing time, however, the battery will only charge with the power OFF. TROUBLESHOOTING If your Amp Can is set up but does not function, check the following items: THE FENDER 2244TM Constructed from 1/2 inch (1. 27 cm) PVC and HighImpact ABS Plastic for Long-Lasting Durability 12V, 4. 5 Amp Hour Rechargeable Sealed Lead Acid Battery provides 4 to 6 Hours of Power Input Channels for Guitar, Instruments and Mic with Individual Volume and Tone Controls Allowing the Input Channels to be Mixed Separately Rugged Steel Carrying Handle and Stand Allows the Speaker to be Angled for Optimum Sound Coverage Heavy Duty 6" 4 Paper Coil Former Speaker with 16 oz. Magnet for a Smooth Full-Range Sound Your new Fender Amp Can is designed by the same Tone-Team that has created many other classic Fender amps: like the Tone-Master®, Twin Reverb® and the versatile Hot Rod Series. Built with care and attention to detail, the Amp Can is a great amp by any measure. Designed for street musicians or anyone who needs a portable high quality amplifier, the Amp Can features convenient panel mounted controls and input jacks. Its 12-volt rechargeable battery provides the Amp Can with power for 4 to 6 hours per charge cycle. Aside from its portability, your Amp Can is like any other guitar amplifier. To ensure maximum safety and life from your Amp Can and its battery, please read through thoroughly and heed all safety warnings relating to your Amp Can. WARNING: -TO PREVENT DAMAGE, FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. -USE OF A CHARGER OTHER THAN THE ONE SUPPLIED WITH THIS UNIT MAY RESULT IN RISK OF FIRE, ELECTRIC SHOCK OR INJURY. Once the power LED stays red, the battery should be recharged immediately. Recharging the battery takes approximately 12 to 16 hours. It is important to remember that the longer your Amp Can is played after the LED turns red, the longer it will take to recharge the battery. If your Amp Can is played until it stops operating, it may take 72 hours or more to completely recharge. Moreover, allowing the battery to deeply discharge will significantly lessen the battery's life span. To recharge the battery, simply connect the "wall-mount" adapter to the charger input on your Amp Can (item K page 4), then plug it into a wall outlet. In the short term, leaving the charger plugged in for more than 72 hours will not damage your Amp Can or its battery, however, repeated "over charging" of the battery will in time decrease its efficiency and storage capacity. CAUTION: DO NOT CHARGE OR STORE THE BATTERY IN TEMPERATURES ABOVE 122O F (50O C) OR DAMAGE MAY RESULT. Like any battery, extreme heat will significantly lessen your Amp Can's battery life. It is best to recharge and store your Amp Can indoors and at room temperature. If after normal use and maintenance the playing time drops below 2 hours or if the battery takes more than 24 hours to recharge, it may be time to replace the battery. [. . . ] If after normal use and maintenance the playing time drops below 2 hours or if the battery takes more than 24 hours to recharge, it may be time to replace the battery. Contact your nearest authorized Fender dealer for a replacement battery (P/N 050548). H A. MIC INPUT - This is a 1/4 inch, high impedance input for a microphone or acoustic-electric guitar. 10 is the brightest setting becoming progressively less bright as the dial is rotated towards 1. [. . . ]