User manual FELLOWES METAL E-200R

[. . . ] When punching; - always ensure the machine is on a stable surface - test punch scrap sheets and set the machine before punching final documents - remove staples and other metal articles prior to punching - never exceed the machines quoted performance Keep the machine away from heat and water sources. Always call Fellowes before contacting your place of purchase (see the rear cover for contact details. [. . . ] Touch the metal coil against the inserting roller to bind the document. Additional sheets may be include or removed at any time by first removing the old metal coil. The waste tray is located under the machine and is accessed from the front side. Problem The machine doesn't bind/punch Punched holes are not central Machine will not punch Punch holes are not parallel to edge. Partial holes Damaged hole edges Cause Machine is not switched on Edge guide not set Blockage Debris is stuck below dies. Solution Switch on machine at rear Adjust edge guide until hole pattern is correct Check waste tray is empty. Check for blockage to paper entry Take stiff cardboard and slide into the paper entry. Move the cardboard sideways to release any stray clippings into the waste tray Adjust edge guide and test punch scrap sheets until correct Punch plastic covers with paper sheets. Reduce number of sheets being punched Fellowes warrants all parts of the binder to be free of defects in material and workmanship for 2 years from the date of purchase by the original consumer. If any part is found to be defective during warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. [. . . ] Should the time come for you to dispose of this product please ensure that you do so in accordance with the European Waste of Electrical and Electronic Equipment (WEEE) Directive and in compliance with local laws relating to this directive. Fellowes Manufacturing Company Yorkshire Way, West Moor Park, Doncaster, South Yorkshire, DN3 3FB, England declares that the model Metal E 200r conform with the requirements of (RoHS) the Restriction of Hazardous Substances Directive 2002/95/EEC. [. . . ]