User manual FELLOWES DM65C MANUAL-2001

[. . . ] · Never use flammable synthetic oil, petroleum- based or aerosol lubricants to oil the cutting blades. See "MAINTENANCE. " · Do not use this product if it or the cord has been damaged in any way. Doing so can expose you to dangerous voltages and will void your warranty. ASSEMBLY NOTE: This shredder will operate only when used with the supplied basket. The supplied basket has a built-in safety feature which prevents the shredder from operating if used with any other basket or if improperly assembled. To assemble shredder: Confetti cut shredders contain sharp edges on the underside of the shredder head. [. . . ] Do not exceed recommended sheet capacity (see "Product Usage Guide" on front cover of this manual). Slide paper straight into paper entry until the shredder automatically begins shredding. The shredder automatically stops a few seconds after shredding is complete. Continue shredding as desired to a MAXIMUM shredding time of 10-12 minutes. At this time, the machine MUST be allowed to "cool down" for a MINIMUM of 20 minutes. (See "Cool-Down Cycle" for more information. ) If the shredder jams or shuts off before the maximum shredding time, see "Clearing a Jam" section for further instructions. Unplug power cord from outlet whenever shredder is unattended or not in use. Replace basket into cabinet. the shredder's red LED will light and the shredder will automatically stop until the jam is cleared. (NOTE: If waste basket is full, empty it before clearing jam. ) The shredder will reverse the paper to clear the jam. If the shredder jams in reverse, move the power switch to AUTO (I) and allow to run for about five seconds. If jam does not clear, move power switch to REVERSE (R) again and allow to run for about five seconds. If necessary, use care to grasp the paper carefully and pull out to clear the jam. Once the jam is cleared, move the power switch to AUTO (I) for continued shredding or OFF (O) if shredding is complete. MAINTENANCE Confetti-cut shredders require regular (monthly) oiling of the cutting blades to maintain proper operation. Failure to oil the blades regularly could result in reduced sheet capacity performance, excessive noise during operation, paper jams and possibly shredder failure. We recommend using only Powershred Lubricant #35250 (available by contacting Fellowes) or a vegetable-based oil (such as corn or canola) in a non-aerosol container with an extension nozzle. Never use flammable synthetic oil, petroleumbased, or aerosol lubricants to oil the cutting blades. Some agents may combust, causing serious injury. 5. To oil the cutting blades: 1. From the top of the shredder, squeeze the recommended lubricant across the full width of the blades. Move the power switch to AUTO (I) position and allow the blades to run at least 3 seconds. Move the power switch to REVERSE (R) position and allow it to run for at least 3 seconds. [. . . ] For more detail or to obtain service under this warranty, please contact Fellowes Customer Service at 1-800-955-0959, Monday through Friday, 8 AM - 5 PM (Central Standard Time). For specific instructions on obtaining service under this warranty on machines purchased outside the USA, contact the appropriate location listed in the Contact for Service section of this instruction manual. Warrantor: Fellowes Manufacturing Company. Shredder makes a loud squeaking or rubbing noise. a. See "MAINTENANCE" section. Shredder suddenly stops while shredding. a. [. . . ]