User manual FELLOWES BLUEVOICE

[. . . ] · Charge the headset for at least 4 hours before using it · Use only the charger supplied with the headset (Other chargers may damage unit and void the warranty) · Use the table on page 3 as a reference for charging status PLEASE NOTE: If the headset is fully charged and you plug it into the charging adapter, the LED Indicator Light may not light up at all. Contents Overview . 9 Earglove BlueVoiceTM Headset Controls 1 2 Charging & LED Indicator Light Table Status Power Off Power Up and Down Standby Connected Talking Pairing Charging Fully Charged Low Battery LED Indicator Light No LED light LED light is on for 1. 5 seconds Quick Flash every 5 seconds Flashes every 5 seconds Flashes every 1 second Flashes red and green alternately Steady LED light Steady LED light or no light at all Flashes Red while headset is in use Color -- Green Green Green Green Red/Green Red Green Red Battery Level Indication The battery level can be checked in standby mode or when connected by pressing and holding the Answer/End button, then sliding and holding the Volume switch upward simultaneously. The red LED Indicator Light will flash as follows: Status High Mid Low LED Indicator Light 3 Flashes 2 Flashes 1 Flash Figure 4 Adjusting the Boom Your headset has an extendable boom microphone to enhance sound in noisy environments. To extend the microphone, gently hold the tip and pull it toward your mouth. [. . . ] The headset LED Indicator Light will now flash green every few seconds. To manually exit pairing mode, hold the volume switch up or down for 2 seconds until the LED Indicator Light stops flashing red/green. PLEASE NOTE: If pairing does not work, wait 90 seconds, reset your phone or device to the beginning of the Bluetooth® pairing process and repeat steps 1-7. Once pairing is complete, your headset will work with your mobile phone any time both units are powered on and in close proximity to each other. To Pair in Headset and/or Hands Free Mode 1. Activate the Bluetooth® function on your mobile phone or other device. To force the headset into pairing mode, slide and hold the volume switch up or down for approximately 7 seconds until the LED Indicator Light flashes an alternating green and red. Make sure the headset and your mobile phone are close to each other while pairing. When the headset enters pairing mode, use your Bluetooth® mobile phone to find it. Follow the Bluetooth® pairing/set-up instructions and screen prompts on your phone to pair it with the headset. Please refer to your phone's owners manual or go to www. fellowes. com/bluetooth for links to popular phone manufacturers' websites. Due to the multi-pairing feature, if a connection failure occurs, the headset will try to connect to the next most frequently used device on its stored list of devices. If the headset cannot find a device with which to connect, it will go into pairing mode. SECTION 4: General Operation Adjusting the Volume To increase volume, slide volume switch upward for each higher volume level. To decrease volume, slide volume switch downward for each lower volume level. During volume adjustment, you will hear short high tones getting louder through the earpiece as the volume goes up and softer as the volume goes down. Turning Headset On/Off To Turn the Headset On Press and hold the On/Off switch for 2 seconds. If the headset is already paired to a mobile phone and the phone is turned on, the LED Indicator Light will flash green for 1. 5 seconds and then every 5 seconds while on or in standby mode. If headset is not paired to a phone, it will go into pairing mode. Pairing Profiles The BlueVoiceTM Headset supports both Hands-Free and Headset profiles. The headset will automatically select a profile to use with your paired device. It will first try to select Hands-Free mode if supported by your phone. Usually, mobile phones that support both modes will select Hands-Free mode. PLEASE NOTE: Hands-Free mode offers added functionality (see your phone's owners manual). [. . . ] IN NO EVENT SHALL FELLOWES, ITS AFFILIATES, SUBSIDIARIES, RELATED ENTITIES OR THEIR RESPECTIVE OFFICERS, DIRECTORS, OR EMPLOYEES, BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, EXEMPLARY, OR SPECIAL DAMAGES. To make a claim write to WARRANTY CLAIMS, Fellowes, Inc. , 1789 Norwood Ave. , Itasca, IL, 60143. Answering/Rejecting a Call To Answer a Call When the phone rings or when you hear your phone ring through the earpiece, press the Answer/End button once. End the call by pressing the Answer/End button again, or the appropriate key on your phone. To Reject a Call When the phone rings or when you hear your phone ring through the earpiece, press and hold the Answer/End button until the phone or the headset stops ringing. [. . . ]