User manual FELLOWES BLUESPORT

[. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to your device not expressly approved by Fellowes can void the user`s authority to operate the equipment. The Bluetooth® logo and trademarks are owned by Bluetooth SIG, Inc. [. . . ] To wear earpiece on the left ear, change the orientation of the ear hook as follows: Gently grasp the ear hook and pull it off the speaker housing (1) then flip it over to the position shown in (2) and replace it onto the speaker housing. Figure 3 Folding the Boom of Your Earpiece Your earpiece has a folding boom for easy storage when the unit is not being worn. To fold the boom, hold the tip and rotate it towards the housing until it folds flat. Figure 4 Putting on Your Earpiece First, place the ear hook at the top of your ear, with the end of the hook behind your ear. Then, gently slide the hook of the earpiece behind your ear using a slight rotational motion as shown in Figure 5. Once the hook is in place, gently position the earpiece against your ear for a secure fit. Figure 2 NOTE: The charging adapter is `keyed` to fit only one way into your earpiece. Do not force the adapter cable into the connecting port of the earpiece as this may damage the earpiece and void your warranty. Figure 5 4 BlueSport_1Manual 6 language. qx 12/12/03 11. 28 AM Page 5 SECTION 3: Pairing Earpiece to Your Phone Before you use the earpiece for the first time, you must pair the earpiece with your mobile phone. Please refer to the owner`s manual of your phone for instructions on activating the Bluetooth® pairing function. To pair the earpiece, press the pairing button once until the LED indicator light on the earpiece flashes an alternating green and amber. Follow the Bluetooth® pairing/set-up instructions and screen prompts on your phone to pair it with the earpiece. Please refer to your phone`s owners manual or go to www. fellowes. com/bluetooth for specific pairing instructions. If pairing is successful, the LED indicator light will show solid green for 4 seconds and then switch off. To pair in Hands Free mode: Follow steps 1 and 2, and then press the pairing button again. The LED indicator light will flash alternately amber and green at a faster cycle. PLEASE NOTE: Most Bluetooth® phones will pair with the earpiece in Headset mode, but some will also pair in Hands Free mode which provides additional functionality (see your phone`s owners manual for more information). Pairing in Hands Free mode automatically pairs the headset in Headset mode as well. If pairing does not work, wait 90 seconds, reset your phone or device to the beginning of the Bluetooth® pairing process, and repeat steps 1-5. Once pairing is complete, your earpiece will work with your cell phone any time both units are powered on and in close proximity to each other. Resetting the Earpiece When pairing the earpiece to a new Bluetooth® device, the earpiece resets itself to its default settings. volume) to the original setting. SECTION 4: General Operation To turn the earpiece on: Flip the on/off switch to the on (l) position. To turn the earpiece off: Flip the on/off switch to the off (0) position. The unit will immediately turn off without any additional signal. Figure 6 5 BlueSport_1Manual 6 language. qx 12/12/03 11. 28 AM Page 6 Adjusting the Volume: · To increase the volume, press the volume up (+) button for each volume level increase. [. . . ] End the call by pressing the answer/end button, or the appropriate key on your phone. Please refer to your phone`s user manual or documentation for more information on voice dialing and control. Troubleshooting As new phones and Bluetooth® devices are released at an increasing rate, there may be updated pairing and operational instructions available online for your particular device. This warranty extends only to the original retail purchaser, and does not apply if the product has been damaged or fails to function properly as a result of misuse, abuse, alteration, or improper cleaning or maintenance. [. . . ]