User manual FEDDERS HB30

[. . . ] Failure to follow these precautions could result in electrical shock, fire or personal injury. 5 amps, it must have its own fuse or circuit breaker, and no other device or unit should be operated on that fuse or circuit breaker. If the air conditioner has a serial plate rating of 230 volts, it must have its own fuse or circuit breaker, and no other device or unit should be operated on that fuse or circuit breaker. We recommend that a qualified electrician install unit in accordance with the National Electrical Code and local codes and ordinances. [. . . ] (Do not release your grip on the cabinet until the lower window sash is in its final position). Attach the cabinet to the window sill by driving one 1" long wood screw through the bottom bar into the window sill. Air conditioner should slant slightly downward on the outside as shown by 1/2 a bubble off on a carpenter's level. Secure top of filler panels by driving a 5/8" wood screw through each top mounting hole into window sash. Secure bottom of filler panels by driving a 5/8" wood screw into window sill through each filler panel tab. Do not obstruct the air intake area of your air conditioner, as this could cause overheating, thus activating the unit's security switch and shutting off the unit. Do not block airflow outside with shrubs, enclosures, or other buildings. Replace the two anti-theft screws at the bottom front sides of cabinet. To replace the decorative front, line up the top tabs and sides, and gently press into position. Make sure the power cord aligns with the power cord slot on the bottom of the decorative front. Make sure the decorative front is secure before reconnecting the plug and operating the unit. Shows the set temperature when the unit is in operation and hours when the timer is being set. These buttons are used to raise or lower the set temperature in increments of 1° from 66°F to 88°F. By depressing both buttons at once, the display will toggle between Celsius and Fahrenheit. When the timer is being set, these buttons are used to change the hour setting in increments of 1 from 00 to 24. Heat Mode (Heat Models Only) ­ The unit will circulate and heat the air. Heater Safety Feature- When heater is powered off, low fan will automatically stay on and run for 60 seconds to ensure the removal of residual heat, meanwhile, the Low Fan LED blinks until the low fan stops. Energy Saver Mode ­ (The energy saver mode is designed to operate with Cool mode only). The fan will switch from the set fan speed to Low whenever the compressor turns off in response to the thermostat. When the compressor cycles back on, the unit will return to the original fan setting. The settings are adjusted with the Fan Speed Control, each time the button is depressed it changes the setting. When the Auto feature is selected while the air conditioner is in the Cool or Heat mode, the fan speeds will change automatically as the temperature in the room changes. [. . . ] To display the amount of time left until SHUT-DOWN, push the Timer button once. A green light next to the Timer button indicates that the timer is set. Heat/Cool models or units with electric heat are designed to be used only as a supplemental heat source. They should be used in addition to regular heating systems and never as the primary source of heat. [. . . ]