User manual FBII XL-21

[. . . ] Enter your 4-digit User Code (or press the DISARM button on your keyfob). System Turn On/Stay Inside Check to make sure the system is ready -- Green READY LED is lit. Press STAY followed by your User Code. The ARMED and STAY LEDs light. You must turn the system off if you want to open the door or leave the premises after the exit time has passed. [. . . ] One path of escape should lead to the door that permits normal exit from the building. The other is an alternative route, such as through a window, should your normal escape path be unpassable. Station an escape ladder at such windows if there is a long drop to the ground. Keep these routes free from obstruction and post copies of the escape routes in every room. Establish a common meeting place outdoors, away from your house, where everyone can meet and then take steps to contact the authorities and account for those missing. Choose someone to assure that nobody returns to the house -- many die going back. ­ 23 ­ RADIO FREQUENCY EMISSIONS STATEMENTS FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 15 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. INDUSTRY CANADA This Class B digital apparatus complies with Canadian ICES-003. Cet Appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. TELEPHONE/MODEM INTERFACE STATEMENTS FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 68 This equipment complies with Part 68 of the FCC rules. On the front cover of this equipment is a label that contains the FCC registration number and Ringer Equivalence Number (REN). You must provide this information to the telephone company when requested. This equipment uses the following USOC jack: RJ31X This equipment may not be used on telephone-company-provided coin service. La terminaison d'une interface téléphonique peut consister en une combinaison de quelques dispositifs, à la seule condition que la somme d'indices d'équivalence de la sonnerie de tous les dispositifs n'excède pas 5. TELEPHONE OPERATIONAL PROBLEMS In the event of telephone operational problems, disconnect the control by removing the plug from the RJ31X wall jack. We recommend that your certified installer demonstrate disconnecting the phones on installation of the system. Do not disconnect the phone connection inside the control/communicator. If the regular phone works correctly after the control/communicator has been disconnected from the phone lines, the control/communicator has a problem and should be returned for repair. If upon disconnection of the control/communicator, there is still a problem on the line, notify the telephone company that it has a problem and request prompt repair service. The user may not under any circumstances (in or out of warranty) attempt any service or repairs to the system. It must be returned to the factory or an authorized service agency for all repairs. This control unit was manufactured under rigid quality standards and complies with all UL requirements for its intended use. Maintenance is best performed by your installing company with trained service personnel. O560 DECLARATION OF CONFORMITY Application of Council Directives 98/482/EC, 89/336/EEC, 73/23/EEC Standards to which conformity is declared: ETS 300 001:1997 EN50081-1 EN 50130-4:1995 EN 60950:1998 Intended use: Alarm system, analogue subscriber interface to PSTN Restrictions: None EMC environment: RESIDENTIAL, COMMERCIAL AND LIGHT INDUSTRY Manufacturer: FIRE BURGLARY INSTRUMENTS, INC Address: 180 Michael Drive, Syosset NY 11791, USA Customer support: Contact your local distributor ­ 25 ­ System Limitations While this system is an advanced-design security system, it does not offer guaranteed protection against burglary, fire, or other emergency. Any alarm system, whether commercial or residential, is subject to compromise or failure to warn for a variety of reasons. For example: · Intruders may gain access through unprotected openings or have the technical sophistication to bypass an alarm sensor or disconnect an alarm warning device. [. . . ] When lit, some part of the burglar alarm system is on; when not lit, the burglary portion of the system is off. ON-STAY: A system setting that turns on the perimeter protection of the building but allows movement throughout the inside. PANIC BUTTON: A pushbutton that allows you to signal the central station that you need immediate assistance. Your system has programmable Keypad Send Help Alerts that can also serve as Panic buttons. ­ 30 ­ Glossary (cont'd) PERIMETER ZONE: A group of points that protects the exterior of your premises such as your outside doors and windows. [. . . ]