User manual FALMEC WALL RUSTIC

[. . . ] Any modifications that may be required to the electrical system for the installation of the range hood must only be made by qualified electricians. It is dangerous to modify or attempt to modify the characteristics of this system. In the event of malfunctions or if repairs are required to the appliance, do not attempt to solve the problems directly. For all repair and other work on the appliance, contact an authorised service/spare parts centre. [. . . ] LIGHT- button Pressed: the light is on Released: the light is off MOTOR button - 1, 2, 3, OFF 1: starts the motor at minimum speed 2: starts the motor at medium speed 3: starts the motor at maximum speed OFF: stops the motor OFF: light off; Pushbutton Press to reduce motor speed Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the timer LEDs). Pushbutton + Press to increase motor speed Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the timer LEDs). The function "desired speed" enables to start the motor at the speed that was selected before the hood was last turned off. WARNING: Install the hood away from sources of electromagnetic waves, as these could affect the correct operation of the electronic system. The maximum operating distance could be less than 5 metres in case of electromagnetic interference by Light pushbutton on remote control: light on/off. ­ and + pushbutton: increase/decrease speed (to start the motor press either the + or the ­ pushbutton). Instructions for changing the code (only in case of malfunctions caused by interferences): Disconnect the hood from the power supply Remove the cover of the remote control, change the code with the levers. Connect the hood to the power supply and make sure the lights and the motors are off. When the red LED of the control panel lights up press any of the buttons on the control panel. timer and `filter clogged' alarm pushbutton · This function allows the automatic turning off of the hood after running for 15 minutes at the speed previously set (the pushbutton shows a flickering light). After about 30 hours of running the pushbutton indicates the need for washing the metal filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton for a few seconds until the red light turns off. Then turn the hood off and on again to check that the alarm has disappeared. To remove the metal grease-trapping filter, simply pull the handle A until releasing it from the front guide; then tilt it slightly downwards, and slide it out of the rear guide. The two filters located at the ends of the motor can now be easily accessed. In case of hood with the motor box the filter is located on the botton part of the motor box. To order new filters, use the coupon enclosed with this booklet or provided by the distributor. Replace the light bulb: Make sure the appliance is disconnected from the mains power supply. Replace the light bulb with the same model as the original (max 25 W, see the markings near the light). Light bulbs with different shapes and power ratings from the original may seriously damage the light compartment. To replace the lamp for "Round halogen light": a) Make sure the appliance is disconnected from the mains power supply. B) Remove, by levering with a screwdriver, the support ring A for the cover glass. [. . . ] Round halogen light Auswechseln der Lampe "Dicroic lamp": a) Sich vergewissern, dass das Gerät nicht an das Stromnetz angeschlossen ist. Square halogen light (partie réservée au personnel qualifié pour le montage de la hotte) Distance minimale: distance entre la surface de support des casseroles sur la table de cuisson et la partie la plus basse de la hotte. Quand la hotte est placée au-dessus d'un appareil à gaz, cette distance doit être d'au moins 65 cm (voir figure C1). Si la notice de l'appareil à gaz indique une distance supérieure, il faut en tenir compte. [. . . ]