User manual EUROFLEX EZ 2 SUPERCLEAN

[. . . ] €¢ Prior to using the appliance, make sure the iron is securely connected to the ironing board steam valve. Failure to secure the connection could potentially lead to steam escaping, and the risk of scalding. €¢ Neither the appliance should be used if there are visible signs of damage or leakage. €¢ The manufacturer declines any responsibility for damage to persons or equipment, in the event that the equipment is damaged as a result of improper use, unauthorised repair or maintenance work. [. . . ] B 90° • Align the Handle Assembly screw hole with the opening in the steamer housing. Secure the handle assembly with self-tapping screw which was removed from bottom of Extension Tube (as shown in Fig. Attach Hard Surface Floor or Carpet Pad to Steamer Affix either the Hard Surface Floor Pad or Carpet Glide with Carpet Pad to your Floor Steamer. WARNING: To prevent floor damage, ALWAYS attach either the HARD SURFACE FLOOR PAD or the CARPET GLIDE ACCESSORY with CARPET PAD when using your Floor Steamer. ATTACHING HARD SURFACE FLOOR PAD Place Floor Pad face down on the floor, wide side forward, with white hook and loop strips facing up. Hold Floor Steamer about 2” above Pad and gently place Floor Steamer onto the Pad. Firmly press down to assure Pad is securely adhered to the Floor Steamer. aTTACHING CARPET GLIDE WITH CARPET PAD Place Carpet Glide face up on floor. Center and place Carpet Pad on top of Carpet Glide, wide side forward, with white hook and loop strips facing up. Hold Floor Steamer about 2” above Pad and gently place Floor Steamer onto the Pad. Firmly press down to assure Pad is adhered to the Floor Steamer and Carpet Glide is securely attached. uSE ON HARDWOOD FLOORS For hardwood floors , use only on “sealed” hardwood surfaces. Carefully control the amount of steam usedwhen cleaning, as too much water could cause damage IMPORTANT NOTE ABOUT LINOLEUM FLOORING Steam can cause wax to be stripped from, and consequently damage, some varieties of linoleum flooring. ALWAYS test a small, inconspicuous portion of the floor BEFORE using steam to ensure that your linoleum floor does not have this issue. Filling Boiler with Water WARNINGS: • Carefully read all instructions before removing Boiler Cap. €¢ Always unplug appliance before filling the Boiler. €¢ Be sure appliance is unplugged, and has cooled for at least 10 minutes before filling with water. €¢ Make sure Handle Assembly is in the upright “off” position. Remove Boiler Cap by pressing it down and turning it counterclockwise. IMPORTANT If re-filling the Boiler while Steamer has been in use, be sure to allow Steamer to cool for at least 10 minutes and loosen Boiler Cap slowly to allow any excess steam to escape before com-pletely removing Cap. (See step 2D, “Refilling Boiler During Use” for detailed instructions. ) • Pour in two (2) cups of water using the Measuring Cup provided – fill cup to the “1 Cup” marking two times. [. . . ] Because the subtle green light is positioned next to the more vibrant orange light, it is naturally overpowered by the brighter color. The steam seems to be Steam Nozzles are being used making my floor too wet. IMPORTANT QUESTION: Q: Do I always need to use a Microfiber Pad when cleaning with my Steamer?The Floor Steamer should NEVER be used without either a Hard Surface Floor Pad or Carpet Glide with Carpet Pad. [. . . ]