User manual ESCALADE SPORTS M01473-2003

[. . . ] Sunlight or Halogen lighting may have an effect on the infrared sensors performance. Do not put directly in front of a window. READ AND FOLLOW ALL ASSEMBLY, OPERATION, AND SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO ADULTS ARE NEEDED TO PUT THIS GAME TABLE TOGETHER! 2 3 4 CAUTION: Assemble the unit in the room you wish to keep it in. It will NOT fit through a standard door opening when completely assembled. 1. [. . . ] Make sure the foam pad is between the electronics and the backboard. IMPORTANT Please remove the metal corner protectors before board assembly. 2. The order does not matter on the brown and white set of wires as long as you match the colors. 10 3. Attach the 4 board brackets H12 to the backboard P11 using bolts H7, washers H8 and nuts H3. Make sure the smaller holes are aligned as those holes are used in the next step. 4. Attach the cloth face P12 with 8 bolts H5, 8 plastic spacers H6, 8 washers H9 and 8 nuts H10. Tighten hardware at this time. 11 THIS STEP REQUIRES 2 OR MORE ADULTS! 9. With the help of another adult, lift the backboard assembly into position. Attach the lower brackets to the frame using 2 bolts H2 and 2 nuts H3. Attach the upper brackets to the frame using 2 bolts H2, to ramp net hooks H11 and 2 nuts H3. (See DETAIL 2) 12 CAUTION: WHEN ATTACHING THE RAMP NET BE SURE THE NETTING IS ON THE OUTSIDE OF THE UNIT. 11. Place the ramp net P15 under your frame assembly. Bring the netting to the outside of the unit around the tubes P7 and P7A. Slide the top of the ramp net over tubes P10. 13 12. Wrap the bottom part of the ramp under the backboard and around the lower and upper P5 tubes on the back of the unit and hook the elastic loops around the two hooks H11. Next wrap the velcro staps around the uprights and through the loops in the back of the ramp netting. See details in Figure 12. 14 13. Slide tube P5 through the front of the ramp net as shown. Make sure you bring the ramp under the P5 previously installed in the front of the unit. On the left side attach with bolt H2, switch P13, washer H8 and nut H3. (See DETAIL) Plug the cable from P7A into the back of the switch and the back of the electronics. Connection is correct when the plugs "snap" together tightly. [. . . ] 2 1 1 2 2 2 1 1 1 1 1 1 1 3 1 1 1 1 1 1 17 90 DAY LIMITED WARRANTY This consumer warranty extends to the original consumer purchase of any ESCALADE SPORTS Product (hereinafter referred as the "Product"). WARRANTY DURATION: This Product is warranted to the original consumer purchase of a period of 90 days from the original purchase. WARRANTY COVERAGE: ESCALADE SPORTS warrants to the original Consumer Purchaser that any Product of its manufacture is free from defects in material and workmanship when used for the intended purpose under normal use and conditions. THIS WARRANTY IS VOID IF THE PRODUCT HAS BEEN DAMAGED BY ACCIDENT, UNREASONABLE USE, NEGLIGENCE, IMPROPER SERVICE, FAILURE TO FOLLOW INSTRUCTIONS PROVIDED WITH THE PRODUCT OR OTHER CAUSES NOT ARISING OUT OF DEFECTS IN MATERIAL AND WORKMANSHIP. [. . . ]