User manual ESCALADE SPORTS JR

[. . . ] Escalade Sports will not be liable for any other damages or expenses which may incur, including but not limited to incidental or consequential damages. Escalade Sports assumes no other obligations or liability on the part of the purchaser, and Escalade Sports neither assumes nor authorizes any other person to assume for it any other liability in connection with the goods sold. What is Not Covered by This Warranty · · · Any merchandise subjected to abuse, negligence, improper installation, vandalism, acts of God, alteration of product, or any other events beyond the control of Escalade Sports. HANGING ON RIM WILL VOID YOUR WARRANTY: Rims are not warranted for any defects other than workmanship. Torn back plates, damaged springs, bent rings, damaged eyebolts, and torn or distorted rim supports result from hanging on the rim and are not warranted. [. . . ] Place four reinforcement bars 8" apart forming a square in center of hole. Finish pouring concrete into hole leveling it with top of cardboard form. Push anchor system into concrete until anchor template makes contact with concrete. Agitate anchor system before final placement to work out voids in concrete. Immediately use a level to square and level anchor system to playing surface. Clean off any concrete that may be on the exposed threads of the four anchor bolts. . . "' `$' z post lock i -5/V split washer For installation questions cdl: I-888~USA-GOAL. This model is a Goakilla JR. . Part 2. (Just a few things we have learned through installer feedback) Note: It is very important for the installer to understand the necessity of the nylon washers provided in the hardware pack. Neglecting the use of these washers will result in rusted parts. Note: DO NOT over tighten pivot points. Over tightening pivot points will damage tubing and will make adjustment of system more difficult. Just remember: Good and snug is suflicieni at all pivot points. - refer to drawing to assist in assembly STEP 1. Assemble actuator sleeve onto actuator. Lay post on its side on two padded saw horses and assemble the following: Insert 1" bolt through I/2" split washer, l/2" Rat washer, l/2" nylon washer `and actuator. Align middle holes of lower arm with welded round tube located 21" from top of post. Insert 9" bolt through 112" flat washer, 112" nylon washer, lower arm, another nylon, post, another nylon, other side of lower arm, another nylon, another flat and l/2" lock nut. STEP 2. STEP 3. Insert 9" bolt through 112" flat washer, I/2" nylon washer, lower arm, another nylon, actuator spacer, another nylon, other side of lower arm, another nylon, another flat and l/2" lock nut. Align holes on narrow end of upper arm with welded round tubing located I" from top of post. Insert 9" bolt through l/2" Rat washer, l/2" nylon washer, upper arm, another nylon, post, another nylon, other side of upper arm, another nylon, another flat and l/2" lock nut. At this time you are ready to position the post upright onto the anchor system. If so, gather 3 capable persons and have them assist you in positioning post onto anchor system. [. . . ] Using a pencil, place a mark on the actuator right below the actuator sleeve. While maintaining decal in a vertical position, line up 10 foot mark on decal with mark you made on actuator and carefully adhere decal to actuator. Use post lock to secure goal height adjustment. CONGRATULATIONS ! You have just completed assembly of the finest residential basketball system in the country. Care Information Backboard Items needed to clean backboard: - 100% cotton soft cloth. (only) - Mild dish washing liquid for soap - Luke warm water - Mild plastic polish to minimize scratches Rinse backboard with lukewarm water. [. . . ]