User manual EPSON STYLUS SX415 BASIC OPERATION GUIDE

[. . . ] Do not use aerosol products that contain flammable gases inside or around the printer. Except as specifically explained in your documentation, do not attempt to service the printer yourself. Keep ink cartridges out of the reach of children and do not drink the ink. If you still have discomfort or vision problems, see a doctor immediately. [. . . ] You can also start this operation by entering F Setup mode, Maintenance, and then Change Ink Cartridge. If non-genuine ink cartridges are installed, the ink cartridge status may not be displayed. Print head cleaning uses ink from all cartridges, so clean the print head only if quality declines. If quality does not improve after cleaning four times, turn off the printer for at least six hours. Depending on the settings on this printer and the digital camera, some combinations of paper type, size, and layout may not be supported. Some of the settings on your digital camera may not be reflected in the output. Ink Levels Maintenance Nozzle Check Head Cleaning Head Alignment Change Ink Cartridge Language Display Format PictBridge Setup Restore Default Settings 1-up with Info, 1-up without Info, View Thumbnail Images Turn off the printer, open the scanner unit, remove paper. The printer's ink pads are nearing the end of their service life. R & 52 R & 56 R & 56 R & 57 R & 20 Turn the printer off and then back on. Contact Epson support to replace ink pads before the end of their service life. When the ink pads are saturated, the printer stops and Epson support is required to continue printing. Make sure the memory card or storage disk has been inserted correctly. If so, check to see if there is a problem with the card or disk and try again. O Some ink is consumed from all cartridges during the following operations: print head cleaning and ink charging when an ink cartridge is installed. O For maximum ink efficiency, only remove an ink cartridge when you are ready to replace it. The use of non-genuine ink may cause damage that is not covered by Epson's warranties, and under certain circumstances, may cause erratic printer behavior. Information about non-genuine ink levels may not be displayed, and use of non-genuine ink is recorded for possible use in service support. O Make sure you have a new ink cartridge before you begin replacement. Once you start replacing a cartridge, you must complete all the steps in one session. o Leave the expended cartridge installed until you have obtained a replacement. [. . . ] If a moiré (cross-hatch) pattern appears on your copy, change the Zoom setting or shift the position of your original. Make sure you selected the correct Paper Size, Layout, Expansion, and Zoom setting for the loaded paper. R & 26, 35 Make sure you loaded paper and placed the original correctly. R & 16, 20 If the edges of the copy or photo are cropped off, move the original slightly away from the corner. [. . . ]