User manual EPSON ELPMB22 INSTALLATION MANUAL

[. . . ] When you set the projector on a wall with this mount, the wall requires enough strength to hold the projector and this mount. a wall of reinforced concrete or steel skeleton construction is recommended. Confirm the mass of the projector and the mount, and keep the strength of the wall. If the wall does not have enough strength, reinforce the wall before installing. [. . . ] Epson takes no responsibility for any damage or injury caused by incorrect installing. The installation work should be performed by at least two qualified service personnel. If you need to loosen any screws while installing, be careful not to drop the mount. If the mount or the projector falls down, it could cause personal injury or property damage. Doing so could cause the arm unit to fall and cause personal injury or property damage. If the projector or the arm unit falls down, it could cause personal injury or property damage. Stop using this mount and contact the customer support office listed on Epson Projector Contact List in the User's Guide of your projector when the following trouble occurs. If you use adhesives to prevent the screws from loosening or things such as lubricants or oils on the mount, the case may crack and this could cause the projector to fall. If the screws are not properly tightened, it could cause the projector to fall and cause personal injury or property damage. If the screws are not properly tightened, it could cause the projector to fall and cause personal injury or property damage. Do not install at place where there is a lot of dust, or a place where it may come into contact with smoke or steam such as near cooking appliances or a humidifier. ) space between the top of the whiteboard and the bottom of the wall plate. If the 16:9 of maximum distance (tele) screen size is used, refer to the table in the previous page. Horizontal center of the wall plate If you insert at four points, use four point As or four point Bs as shown below. When you set the projector on the wall with this mount, the wall requires enough strength to hold the projector and this mount. a wall of reinforced concrete or steel skeleton construction is recommended. Confirm the mass of the projector and the mount, and keep the strength of the wall. If the wall does not have enough strength, reinforce the wall before installing. install the mount firmly to hold the mass of the projector and the mount , and to resist horizontal vibration. Epson takes no responsibility for any damage or injury caused by incorrect installing. Attaching the arm unit to the wall plate 1) 2) 3) Route the cables through the arm unit as shown below. Be careful not to pinch cables between the arm plate and the wall plate. [. . . ] Wall plate Bar of the wall plate Attach the projector plate to the projector using the hexagon wrench (M4) and five M4 × 12 mm bolts. If you use adhesives to prevent the screws from loosening or things such as lubricants or oils on the mount, the case may crack and this could cause the projector to fall. 1) 2) Slide the projector plate onto the adjustment unit as shown below. ( ) Adjust the length of the arm using the measure on the bottom to match the projection distance recommended in "Screen Size and Projection Distance" on page 6. [. . . ]