User manual EPOQUE EHS-1000 HD

[. . . ] 取 扱 説 明 書 Instruction Manual Epoque Digital Underwater Housing Mod. EHS-1000 HD for SANYO Digital Movie Camera Xacti DMX-HD1000/VPC-HD1000 本取扱説明書をお読みになる前に… ご使用前にお読み下さい… 1. 17 Before reading this instruction manual… Before use… 1. About battery and number of picture… 10. Maintenance… 11. About the accessories… 12. Specification… P. [. . . ] Checking beforehand is the special valuable for joyful diving recording, so checking every time is preferred. When the water-leakage is occurred in spite of checking beforehand, please stop using and consult with the dealer you bought at. 5. How to install the digital camera Caution: Caution: Caution: Caution: Install the digital camera after checking this product thoroughly. Also be careful not to become crazy about taking pictures, which cause the lack of air. Please note that the focus distance under water would be longer than on land. Please read the instruction manual of the digital camera fully to understand before use it. Do not add excessive power to the buttons, dials or levers, which causes break of parts in this product and factor of troubles. Return the levers to the neutral position (center) after making adjustment. When the digital camera is installed, due to small difference between Fig. 5 the tolerate dimension of this product and the digital camera, there would be possibility that some functions on this product is not operated with the digital camera. In this case, moving levers right and left and the position of internal parts would be set in correct position to clear the problem of the malfunction. Please note that Set-button on this product can not be operated toward to upper direction. With internal high temperature of digital camera the lens would be misted possibly. In this case Stop using this product and remove digital camera from the housing and dry the housing and digital camera completely, and wipe it and store them with ambient temperature for a few hours. To avoid wearing of ditch on lens adapter by installing with other accessories, it’s most preferable to spread the silicon grease thinly on it. Please confirm each buttons, dials or levers to be operated correctly through the LCD monitor while product works 11 Caution: Caution: Caution: Caution: 6-1 How to set this product. (Fig. 6) 2) Do not blind the front face of the lens glass with you fingers. (Fig. 7) 3) In order to prevent camera shake, keep this product by hands firmly. If you would take pictures by one hand, please control by yourself, not to move. Fig. 6 6-2 Functions [ON/OFF button] Push the buttons slowly to be operated. (Fig. 8) [REC/PLAY buttons] 1) Press the button (Fig. 8) and position the projection on the switch of the digital camera and turn Dial slowly. 9 12 Y [Zoom lever] 1) Operate the lever to the T and W direction. After adjust the position for required picture, return Levers to neutral position (center) from selected position. 2) Operate the lever to the opposite direction to the zoom lever of the digital camera. [Still photo button/Movie button] Please hold this product firmly by hands and push the button slowly. [Menu button] [Full-Auto button] [Set button] [Strobe button] Push the button slowly. [. . . ] If salt of salt-water would be remained on there would make rust or the factor of trouble. After remove dirt or others, please wipe up by towel and keep it dry completely at shade place. Caution: Caution: Do not open Rear-case or remove Digital camera from the housing until this product dries completely. When the temperature of this product inside is lower than outside (negative pressure), opening rearcase without dry enough makes moisture inhaled inside this product. [. . . ]