User manual ENVISION EFT720

[. . . ] The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission limits. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to this equipment. has determined that this product meets the ENERGY STAR guidelines for energy efficiency. [. . . ] The DDC2B is a bidirectional data channel based on the I²C protocol. THIS MONITOR WILL APPEAR TO BE NON-FUNCTIONAL IF THERE IS NO VIDEO INPUT SIGNAL. IN ORDER FOR THIS MONITOR TO OPERATE PROPERLY, THERE MUST BE A VIDEO INPUT SIGNAL. This monitor meets the Green Monitor standards as set by the Video Electronics Standards Association (VESA) and/or the United States Environmental Protection Agency (EPA) and The Swedish Confederation Employees ( NUTEK ). This feature is designed to conserve electrical energy by reducing power consumption when there is no video input signal present. When there is no video input signal this monitor, following a time-out period, will automatically switch to an OFF mode. After the video input signal is restored, full power is restored and the display is automatically redrawn. The appearance is similar to a "Screen Saver" feature except the display is completely off. The display is restored by pressing a key on the keyboard, or clicking the mouse. USING THE RIGHT POWER CORD: The accessory power cord for the Northern American region is the wall plug with NEMA 5-15 style and is UL listed and CSA labeled. Supplied with units intended for connection to power outlet of personal computer: Please use a cord set consisting of a minimum No. One end terminates with a grounding type attachment plug, rated 10A, 250V, CEE-22 male configuration. The other end terminates with a molded-on type connector body, rated 10A, 250V, having standard CEE-22 female configuration. TECHNICAL SUPPORT(FAQ) Power LED is not on *Power Cord should be connected No Plug & Play *Check if the PC System is Plug & Play compatible *Check if the Video Card is Plug & Play compatible *Check if the D-15 plug pin of Video Cable is bent *Make sure the AOC Monitor Drivers are installed (AOC Monitor Drivers are available at: www. ENVISIONdisplay. com) Picture is fuzzy *Adjust the Contrast and Brightness Controls. Picture bounces or a wave pattern is present in the picture *Move electrical devices that may cause electrical interference. *Make sure monitor's video cable is properly connected to the computer. *Inspect monitor's video cable and make sure none of the pins are bent. *Make sure computer is operational by hitting the CAPS LOCK key on the keyboard while observing the CAPS LOCK LED. Missing one of the primary colors (RED, GREEN, or BLUE) *Inspect the monitor's video cable and make sure that none of the pins are bent. INSTALLATION INSTRUCTIONS SWIVEL BASE To attach the swivel base to the monitor, do the following: · Carefully turn the monitor on its side or upside down. (see figure 1) · Locate the cavities at the bottom front of the monitor. · To remove the swivel base, hold the bottom of the swivel base, then push it out. Make sure the power cord is the correct type that required in your area. This monitor has a universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required). [. . . ] Power Indicator On/Off Switch Menu Contrast/Right Brightness/Left Exti Figure 4: The OSD Menu 1024 × 768 FRONT PANEL CONTROL (see figure 3) NT PANEL CONTROL · Power ON/OFF Switch: Press this key to switch the display ON or OFF. · · MENU : Press this key to either bring up the OSD menu or select an item on the menu. Contrast: With the OSD menu on, press this key to either select a function or to adjust up the value of a selected function. · Brightness: With the OSD menu, press this key to either select a function or adjust down the value of a selected function. [. . . ]