User manual ENGENIUS EP-490

[. . . ] Table of Contents User Manual WIRELESS SOLUTIONS PROVIDER EP-490 4-line Wireless Phone System EnGenius Customer Service United States: 1-888-735-7888 Canada: 1-888-397-2788 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Regulatory Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Congratulations. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Equipment Checklist . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To return to the conversation, press "Unhold" (Left) soft key. The call being placed on hold can only be "un-hold" by the handset that puts it on hold. An alert tone (double beep) every 30 seconds will remind the handset that a call is being on hold. If the operation (e. g. , call transfer) after putting a call on-hold fails, the held call may be dropped. You can power off the handset (e. g. , change battery) while call is on hold. After power on again, you can continue the call by pressing UNHOLD (Left) soft key or select "3" from the Option menu to terminate the hold state. Ending a Call To end a telephone or intercom call, press END key or place handset into charger cradle. 33 34 Mute 1. After a link is established, you can press Mute (Left) soft key to mute the handset microphone. When mute is active, the other end will not hear your voice, but still can speak to you. You can replace the handset battery after placing the call-in-progress on hold. 3. Battery talk time and standby time vary depending on the talk/standby pattern and the operating distance. Putting the handset back to charger cradle as often as possible is recommended for best performance. Note: Use only manufacturer provided batteries and charger. Do Not Disturb (Silent Ring) 1. Enter the key sequence MENU ­ Sounds ­ Ring Volume, then select "Off". This will turn off the ringer until it is turn on again from the menu. For temporary silencing the ringer when an incoming call arrives, press Silent (Left) soft key. Key Guard 1. To prevent accidental dialing, you can press Menu (Right) soft key, then select KeyGuard option. To unlock the keypad, press "Unlock" (Left) soft key, then, within 2 seconds, press the digit "1" to unlock. Key Guard is in effect until unlocked or powered off. Battery Recharge and Replacement 35 36 Advanced Operations b. If your handset(s) is purchased as part of a system, it has been pre-registered with the base station at the factory. You need to register the handset with the base station in the following situations: a. If a handset displays a Handset ID "00, " that means it is a new handset or the ID has been erased. For example, you want to change a particular handset from a user to an administrator (ID 10 or 11), or vice versa. [. . . ] Press "2" and confirm to clear the three call logs (Called, Received, and Missed). Press "5" to change the power-up LCD display to show, e. g. , customer name or other greeting message: i. Use Up/Down Arrow to move the cursor backward or forward to insert (to the left of the cursor) or delete (the character above the cursor, or left of the cursor if cursor is on the right of the last character). ii. Enter characters using the Character Table and method discussed in the Phonebook section. [. . . ]